Effect of temperature on anisotropy in forming simulation of aluminum alloys
Source abstract
Abstract
A combined experimental and numerical study of the effect of temperature on anisotropy in warm forming of AA 6016-T4 aluminum was performed. The anisotropy coefficients of the Vegter yield function were calculated from crystal plasticity models with an adequate combination of extra slip systems. Curve fitting was used to fit the anisotropy coefficients calculated at discrete temperatures. This temperature dependent constitutive model was successfully applied to the coupled thermo-mechanical analysis of deep drawing of aluminum sheet and results were compared with experiments.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Metal Forming Simulation Techniques · Metallurgy and Material Forming · Microstructure and mechanical properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (8)
Show source-provided references
1. D. Li and A. Ghosh. Tensile deformation behavior of aluminum alloys at warm forming temperatures. Mater. Sci. Eng. A., 352:279–286, 2003.10.1016/S0921-5093(02)00915-2 ↗
2. H. Takuda, K. Mori, I. Masuda, Y. Abe and M. Matsuo. Finite element simulation of warm deep drawing of aluminum alloy sheet when accounting heat conduction. J. Mater. Proc. Tech., 120:412–418, 2002.10.1016/S0924-0136(01)01180-3 ↗
3. A.H. van den Boogaard and J. Huétink. Simulation of aluminium sheet forming at elevated temperatures. Comp. Methods in Appl. Mech. and Eng., 195: 6691–6709, 2006.10.1016/j.cma.2005.05.054 ↗
4. H. Vegter and A.H. van den Boogaard. A plane stress yield function for anisotropic sheet material by interpolation of biaxial stress states. Int. J. of Plast. 22:557–580, 2006.10.1016/j.ijplas.2005.04.009 ↗
5. S. Kurukuri, A.H. van den Boogaard, A. Miroux and B. Holmedal. Warm forming simulation of Al-Mg sheet. J. Mater. Proc. Tech., Submitted.
6. M. Merklein,W. Hußnätter and M. Geiger. Characterization of yielding behavior of sheet metal under biaxial stress condition at elevated temperatures. CIRP Annals - Manufact. Tech. 57 (1): 269–274, 2008.10.1016/j.cirp.2008.03.032 ↗
7. R.A. Lebensohn and C.N. Tomé. A self-consistent anisotropic approach for the simulation of plastic deformation and texture development of polycrystals: Application to zirconium alloys. Acta. Metall. Mater. 41 (9):2611–2624, 1993.10.1016/0956-7151(93)90130-K ↗
8. B. Bacroix and J.J. Jonas. The influence of non-octahedral slip on texture development in FCC metals. Textures. Aniso 8 :267–311, 1988.10.1155/TSM.8-9.267 ↗