Prediction of Tool Wear Progress in Machining of Carbon Steel using different Tool Wear Mechanismsl
Source abstract
Abstract
In this paper the prediction of tool wear on carbide uncoated tools was taken into account. In particular, two different tool wear models based on the diffusion mechanism and on the abrasion mechanism were considered. The calibration of the utilized models was done using the results obtained by experimental analysis performed on an orthogonally machined AISI 1020 tube. Once the calibration was executed, numerical simulations, for both the utilized tool wear models, were simultaneously performed with the aim to test the capability of the proposed numerical procedure. The comparison between the two tool wear mechanisms for predicting the flank tool wear is discussed in the paper.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced machining processes and optimization · Metal Alloys Wear and Properties · Advanced Surface Polishing Techniques
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (9)
Show source-provided references
1. M.C. Shaw, Metal Cutting Principles (2nd Ed.), Oxford Science Publications (2005).
2. V.P. Astakhov, The assessment of cutting tool wear, International Journal of Machine Tools & Manufacture, 44 (2004) 637–647.10.1016/j.ijmachtools.2003.11.006 ↗
3. L. Filice, F. Micari, L. Settineri, D. Umbrello, On the finite element simulation of thermal phenomena in machining processes, Advanced Methods in Material Forming, (2007) 263–278.10.1007/3-540-69845-0_16 ↗
4. H. Takeyama, T. Murata, Basic investigations on tool wear, Trans. of the ASME - J. Eng. Ind., 85 (1963) 33–38.10.1115/1.3667575 ↗
5. E. Usui, T. Shirakahi and T. Kitagawa, Analytical Prediction of Cutting Tool Wear, Wear, 100 (1984) 129–151.10.1016/0043-1648(84)90010-3 ↗
6. E. Rabinowicz, L. A. Dunn and P. G. Russell, A study of abrasive wear under three-body conditions, Wear, 4 (1961) 345.10.1016/0043-1648(61)90002-3 ↗
7. L. Filice, D. Umbrello, F. Micari, L. Settineri, Wear modelling in mild steel orthogonal cutting when using uncoated carbide tools, Wear, 262/5–6 (2007) 545–554.10.1016/j.wear.2006.06.022 ↗
8. Suhas V. Patankar, Numerical Heat Transfer and Fluid Flow, Hemisphere Publishing Corporation (1980).
9. T. Matsumura, T. Obikawa, T. Shirakashi and E. Usui, Automonus Turning Operation Planning with Predicting Tool Wear and Surface Roughness, In: Transactions of the North American Manufacturing Institution of SME, 21 (1993) 359–366.