Effect of tool wear and forces by turning process on hard AISI 440 C and SCM 440 materials
Source abstract
Abstract
Hard turning technique is new and the management of this process is still limited. AISI 440 C martensitic stainless steel and SCM 440 are alloy steel used as work piece materials for this research work. The stainless steel is difficult to cut material, low thermal conductivity, tendency to form built up edges at tool edge and less corrosion resistant where as SCM 440 is high strength material. The flank wear formed on CBN by stainless steel was more than alloy steel. The crater wear formed on CBN tool while turning stainless steel than alloy steel. The chips produced by stainless steel were saw tooth form and SCM 440 alloy steel did not produce saw tooth chips. Flank wear and crater wear were caused by severe abrasion and also by high heat generated during turning on stainless steel. The flank wear and temperature also contributed on cutting forces on both materials, but very little on stainless steel and more on alloy steel.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced machining processes and optimization · Advanced Machining and Optimization Techniques · Advanced Surface Polishing Techniques
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (10)
Show source-provided references
1. König, W., Hocheschule, T., Komanduri, R., Schenectady, D and Tönshoff, H.K., Machining of hard materials, CIRP Annals, 33(2), pp. 417–427, 1984.10.1016/S0007-8506(16)30003-8 ↗
2. Senhilkumar, A, Rajadurai A and Sornakumar T, The effect of tool wear on tool life of alumina based ceramic cutting tools while machining hardened stainless steel, Journal of Materials Processing Technology, 173, 151–156, 2006.10.1016/j.jmatprotec.2005.11.012 ↗
3. Poulachon G and Moisan L, Hard turning: chip formation mechanisms and metallurgical aspects, Transactions of ASME, Journal of Material Science Eng. 122, 406–412, 2000.
4. Groover M.P: The fundamentals of modern manufacturing process, Wiley Asia Pte. Ltd, 2007,
5. Noordin, M.Y. Venkatesh, V.C. and Sharif, S. Dry turning of tempered martensitic stainless steel using coated cermet and coated carbide tools, Journal of Materials Processing Technology, 185, 83–90, 2007.10.1016/j.jmatprotec.2006.03.137 ↗
6. Huet J.F and Kramer B.M, The wear of ceramic cutting tools, Proceedings of the 10TH NAMRC, SEM, pp. 297–304, 1982.
7. Senussi, Interaction effect of feed rate and cutting speed in CNC turning on chip micro-hardness of 304 – Austenitic stainless steel, International Journal of Applied Science, Engineering and Technology, Volume 4, Number 2.
8. Barry, J. and Byrne, G, Cutting tool wear in the machining of hardened steels, Part I, Cubic boron nitride cutting tool, Wear, 247, 139–151, 2001.10.1016/S0043-1648(00)00531-7 ↗
9. Trent E.M, Metal cutting, 3 rd edition, Butter worth–Heinemann Ltd. Oxford.
10. Ghani M.U, Abukhshim N.A and Sheikh .M. A, An investigation of heat partition and tool wear in hard turning of H13 tool steel with CBN cutting tools, International Journal of Advanced Manufacturing Technology, 39: 874–888, 2008.10.1007/s00170-007-1282-7 ↗