Shear bands and fracture of imperfect Fe+3%Si polycrystals
Source abstract
Abstract
Experimental data on shear macrobands and fracture of flat specimens of Fe+3%Si alloy having only a few grains in a cross-section are analyzed. Four types of band structures that determine the stress-strain curves involving different loading behavior and ductility of the alloy are singled out. The lowest plasticity and strength are exhibited when a singular shear macroband is formed on the front face of a specimen at an angle of 45° to the axis of tension (ep= 3–4%). Formation of a dipole out of two intersecting macrobands on the lateral surface of a specimen increases plasticity (ep= 6–7%). Accommodation bands between the macrobands of the dipole increase the plasticity even more (ep= 9–11%). It is the highest (ep= 19–21%) when the flat grains filling up all of the specimen's cross-section are contained between smaller-sized grains. Ductile fracture of such a specimen is governed by coupling of the conjugate macrobands that interact via a mechanism of auto-oscillations.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Elasticity and Material Modeling · Polymer Nanocomposites and Properties · Elasticity and Wave Propagation
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (18)
Show source-provided references
1. Armstrong, R.W. (1961). On size effects in polycrystal plasticity. J. Mech. Phys. Solids 9 196–199.10.1016/0022-5096(61)90018-7 ↗
2. Deve, H., Harren, S., Mc Cullongh, C. and Asaro, R.J. (1988). Micro and macroscopic aspects of shear band formation in interhally nitrided single crystals of Fe-Ti-Mn alloys. Acta Met. 36 341–365.10.1016/0001-6160(88)90011-9 ↗
3. Essman, U. (1965). Elektronenmikroskopische Untersuchung der Versetzungsanordnung verformter Kupfereinkristalle. Phys. Stat. Sol. 12 723–747.10.1002/pssb.19650120219 ↗
4. Grewen, J., Noda, T. and Sauer, D. (1977). Elektronenmikroskopische Untersuchung an Scherbandern. Zs.Metallk. 68 260–265.
5. Grinyaev, Yu.V. and Panin, V.E. (1978). Calculation of stress-strain state in elasttically loaded polycrystal. Izv. Vyssh. uchebn. zaved. Fiz. 12 95–101.
6. Hakayama, Y. and Morii, K. (1987). Microstructure and shear band formation in cold single crystals of Al-Mg alloy. Acta Met. 35 1747–1756.10.1016/0001-6160(87)90120-9 ↗
7. Harren, S.V., Deve, H.E. and Asaro, R.J. (1988). Shear band formation in plane strain compression. Acta Met. 36 2435–2480.10.1016/0001-6160(88)90193-9 ↗
8. Hull, D. (1962). Twinning and formation of craks in bcc metals. Proc. Int. Conf. on Fracture of Solids. Washington, August 21–24, 1962. Interscience Publischers, New York.
9. Malin, A., Hubert, J. and Hatherley, M. (1981). The Microstructure of rolled copper single crystals. Zs. Metallk. 72 310–317.
10. Panin, V.E. (1998a). Overview on mesomechanics of plastic deformation and fracture of solids. Theor. & Appl. Fract. Mech. 30 1–12.10.1016/S0167-8442(98)00038-X ↗
11. Panin, V.E. (Ed.) (1998). Physical Mesomechanics of Heterogeneous Media and Computer-Aided Design of Materials, Cambridge.
12. Panin, V.E., Syryamkin, V.I., Deryugin, Ye. Ye. et al. (1995). Optical-television techniques for research and diagnostics of materials at mesolevel. Physical Mesomechanics and Computer-Aided Design of Materials (Edited by Panin, V.E.), vol. 1. Siberian book-publishing firm SB RAS Nauka, Novosibirsk, 176–194.
13. Priestner, R. (1962) Twinning and fracture in textured Fe C 3.25%Si steel. Proc. Int. Conf. on Fracture of Solids, Washington, August 21–24, 1962. Interscience Publischers, New York.
14. Sakui, S., Sacai, T. and Sato, K. (1970). The effect of strain rate, temperature and grain size on the lower yield stress and flow stress of FeSi alloys. Proc. Int. Conf. Sci. and Technol. Iron and Steel, Tokyo, Part 2, 1991–996.
15. Tetelman, A.S. (1962). Plastic deformation near tip crak. Proc. Int. Conf. on Fracture of Solids, Washington, August 21–24, 1962. Interscience Publischers, New York.
16. Worthington, P.J. (1968). The nucleation of mechanical twins in polycrystalline 3% silicon iron. Scripta Met. 2 701–703.10.1016/0036-9748(68)90249-4 ↗
17. Yeung, W.Y. and Duggan, B.J. (1987). Shear band angles in rolled f.c.c. materials. Acta Met. 35 541–548.10.1016/0001-6160(87)90259-8 ↗
18. Zasimchuk, E.E. and Marcashova, K.B. (1998). Microbands in monocrystals rolled Ni. Kiev (preprint).