J-integral-based approach to fatigue assessment of laser stake-welded T-joints

Abstract The aim of this paper is to investigate the influence of the plate thickness on the fatigue strength of laser stake-welded T-joints under the tension loading condition. Fatigue tests were conducted on specimens with plate thicknesses below 5 mm subjected to tension loading with the load ratio R = 0. The statistical analysis of the weld geometry showed a normal distribution of the each parameter that was measured. In addition, the parameters had similar proportions in comparison to the specimens with plate thicknesses above 5 mm. FE analysis was performed with the aim of determining the stress state in the joint along with the J-integral. If the square root of the J-integral, √ΔJ, is used as the fatigue strength assessment parameter, the fatigue strength obtained at five million cycles is similar as in the case of other steel welded joint types. The investigation concluded that the stress state changes with the reduction of the plate thicknesses and the contribution of fracture mode II becomes significant. However, using √ΔJ as a fatigue strength assessment parameter ensures that the complex state of the mixed fracture mode loading is accurately accounted for. This fact further enables the fatigue strength of laser stake-welded T-joints of any plate thicknesses to be described by means of a narrower scatterband than the one obtained by the nominal stress approach.