The effect of low cycle fatigue, ratcheting and mean stress relaxation on stress–strain response and microstructural development in a dual phase steel
Source abstract
Abstract
This study examines the cyclic plastic deformation behavior and microstructural development of a dual phase steel in both symmetric and asymmetric cycling in strain and stress control modes. The low-cycle fatigue (LCF) and mean stress relaxation (MSR) tests show very similar fatigue lifetimes. However, fatigue lifetimes reduce and prominent accumulation of directional strain was observed in ratcheting. A microstructural analysis has revealed that the type of cyclic test carried out has a noticeable impact on the substructural development, and this has been correlated with differences in accumulated tensile strain. Electron backscatter diffraction investigation has shown larger in-grain misorientation for ratcheting specimen in comparison with LCF and MSR specimens. The orientation of ferrite grains was found to have very little effect on their substructural development, and strain localization commonly occurred in the ferrite at the ferrite/martensite interface.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Microstructure and Mechanical Properties of Steels · High Temperature Alloys and Creep · Metallurgy and Material Forming
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (29)
Show source-provided references
1. Key issues in cyclic plastic deformation: experimentation10.1016/j.mechmat.2011.07.011 ↗
2. True stress controlled ratcheting behavior of 304LN stainless steel10.1007/s10853-012-6334-1 ↗
3. Cyclic plastic deformation and damage in 304LN stainless steel10.1016/j.msea.2011.03.048 ↗
4. Ratchetting: recent progresses in phenomenon observation, constitutive modeling and application10.1016/j.ijfatigue.2007.10.002 ↗
5. Benchmark experiments and characteristic cyclic plasticity deformation10.1016/j.ijplas.2007.10.003 ↗
6. Recent progresses in experimental investigation and finite element analysis of ratcheting in pressurized piping10.1016/j.ijpvp.2012.10.008 ↗
7. The effect of martensite content on the fatigue of a dual-phase steel10.1016/0142-1123(81)90047-5 ↗
8. Influence of the martensite content on the fatigue behaviour of a dual-phase steel10.1016/0025-5416(87)90281-3 ↗
9. Low cycle fatigue behavior and failure mechanism of a dual-phase steel10.1016/j.msea.2008.09.011 ↗
10. Effect of martensite volume fraction on low cycle fatigue behaviour of dual phase steels: experimental and microstructural investigation10.1016/j.msea.2015.04.059 ↗
11. Paul SK, Stanford N, Hilditch T. Effect of martensite morphology on low cycle fatigue behaviour of dual phase steels: experimental and microstructural investigation. Mater Sci Eng A (Communicated).
12. Cyclic creep process in AISI 316L stainless steel in terms of dislocation patterns and internal stresses10.1016/j.actamat.2004.03.011 ↗
13. Ratchetting process in the stainless steel AISI 316L at 300K: an experimental investigation10.1016/S0749-6419(03)00076-7 ↗
14. Uniaxial ratchetting of 20 carbon steel: macroscopic and microscopic experimental observations10.1016/j.msea.2011.03.113 ↗
15. Dislocation evolution in 316L stainless steel subjected to uniaxial ratchetting deformation10.1016/j.msea.2010.06.020 ↗
16. Macroscopic and microscopic investigations on uniaxial ratchetting of two-phase Ti–6Al–4V alloy10.1016/j.matchar.2014.02.014 ↗
17. Influence of asymmetric cyclic loading on substructure formation and ratcheting fatigue behaviour of AISI 304LN stainless steel10.1016/j.msea.2010.07.107 ↗
18. Influence of dynamic strain aging on the deformation behavior during ratcheting of a 316LN stainless steel10.1016/j.msea.2012.11.115 ↗
19. Uniaxial, load-controlled cyclic deformation of recrystallized molybdenum sheet10.1016/j.msea.2012.01.124 ↗
20. Uniaxial ratcheting and fatigue failure behaviors of hot-rolled AZ31B magnesium alloy under asymmetrical cyclic stress-controlled loadings10.1016/j.msea.2013.03.004 ↗
21. The effect of microstructural representation on simulations of microplastic ratcheting10.1016/j.ijplas.2009.09.004 ↗
22. Cyclic deformation of advanced high-strength steels : mechanical behavior and microstructural analysis10.1007/s11661-008-9732-x ↗
23. Effect of anisotropy on ratcheting: an experimental investigation on IFHS steel sheet10.1016/j.msea.2012.01.058 ↗
24. Uniaxial ratcheting and low-cycle fatigue failure behaviors of AZ91D magnesium alloy under cyclic tension deformation10.1016/j.jallcom.2011.03.129 ↗
25. Assessment of local deformation using EBSD: quantification of accuracy of measurement and definition of local gradient10.1016/j.ultramic.2011.02.004 ↗
26. Local strain distribution near grain boundaries under tensile stresses in highly irradiated SUS316 stainless steel10.1016/j.jnucmat.2012.08.038 ↗
27. Influence of bulk damage on crack initiation in low-cycle fatigue of 316 stainless steel10.1111/j.1460-2695.2009.01420.x ↗
28. Dislocation structures in cyclically strained X10CrAl24 ferritic steel10.1016/j.actamat.2006.03.046 ↗
29. Fatigue softening of X10CrAl24 ferritic steel10.1016/S0921-5093(01)01004-8 ↗