Low-stress creep deformation in two opto-electronic glass-epoxy joints: Part II – Joint measurements and FEA
Source abstract
Abstract
Abstract The creep deformation of two glass-epoxy adhesive joints, representative of joint designs used in opto-electronic devices, was measured at various temperatures and relatively low stress levels using a novel, ultra-sensitive method employing optical interference fringes. The adhesive creep models obtained in Part I were then used as the constitutive equations in finite element models of the joints with the objective of assessing the accuracy of the predictions of creep deformation at the low stresses typical of opto-electronic applications. Good agreement was obtained for both adhesives; however, the higher modulus adhesive was more complicated, exhibiting highly non-linear creep behavior as the stress levels approached zero. The lower modulus adhesive was shown to be linearly viscoelastic over the entire range of stresses encountered in the opto-electronic joints.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Mechanical Behavior of Composites · GaN-based semiconductor devices and materials · Advanced Fiber Optic Sensors
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (4)
Show source-provided references
1. Low-stress creep deformation in two opto-electronic glass-epoxy joints: part I – Adhesive creep data
2. da Silva · 2012
3. On determining mixed-mode traction–separation relations for interfaces10.1007/s10704-016-0128-4 ↗
4. Born · 1975