WITHDRAWN: On modelling the behaviour of a ductile adhesive under low temperatures
Source abstract
Abstract
The Publisher regrets that this article is an accidental duplication of an article that has already been published in INT J ADHES ADHES, 47 (2013) 46–56, http://dx.doi.org/10.1016/j.ijadhadh.2013.09.024 . The duplicate article has therefore been withdrawn. The full Elsevier Policy on Article Withdrawal can be found at http://www.elsevier.com/locate/withdrawalpolicy .
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Metal Forming Simulation Techniques · Mechanical Behavior of Composites · Material Properties and Processing
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (34)
Show source-provided references
1. da Silva · 2008
2. da Silva · 2011
3. Die Nietkraftverteilung in Zugbeanspruchten Nietverbindungen mit Konstanten Laschenquerschnitten
4. Stress distribution and design data for adhesive lap joints between circular tubes
5. Prediction of deformation and failure of rubber-toughened adhesive joints10.1016/j.ijadhadh.2003.08.002 ↗
6. Analysis of the non linear behaviour of adhesives in bonded assemblies. Comparison of TAST and ARCAN tests10.1016/j.ijadhadh.2008.04.006 ↗
7. The macroscopic yield behaviour of polymers10.1007/BF00550671 ↗
8. Plastic yielding of a film adhesive under multiaxial stresses10.1016/S0143-7496(99)00033-0 ↗
9. Simulation of strength difference in elasto-plasticity for adhesive materials10.1002/nme.1315 ↗
10. Stress-free temperature in a mixed-adhesive joint10.1163/156856106779024436 ↗
11. An experimental investigation of residual stresses in an epoxy–steel laminate10.1016/j.ijadhadh.2005.07.006 ↗
12. Thermal residual stress analysis of epoxy bi-material laminates and bonded joints10.1016/j.ijadhadh.2010.03.009 ↗
13. In-situ measurement of chemical shrinkage of MY750 epoxy resin by a novel gravimetric method10.1016/S0266-3538(03)00199-4 ↗
14. Effect of thermal expansion coefficient on the stress distribution in solar panel10.1016/j.ijadhadh.2006.01.011 ↗
15. Measurement of the mechanical properties of structural adhesives in tension and shear over a wide range of temperatures10.1163/1568561053148449 ↗
16. Tensile response of graphite/epoxy composites at low temperatures10.1016/j.compstruct.2005.11.031 ↗
17. Thermal residual stresses in bonded dissimilar materials and their singularities
18. On non-linear thermal stresses in an adhesively bonded single lap joint10.1016/S0045-7949(01)00139-0 ↗
19. Analysis of the temperature-dependent behaviour of a ductile adhesive under monotonic tensile/compression-shear loads10.1016/j.ijadhadh.2012.03.009 ↗
20. Assessment of residual stresses during cure and cooling of epoxy resins10.1002/pen.760352309 ↗
21. Modelling anomalous moisture uptake, swelling and thermal characteristics of a rubber toughened epoxy adhesive10.1016/j.ijadhadh.2004.02.002 ↗
22. The effect of residual strains on the progressive damage modelling of environmentally degraded adhesive joints10.1163/1568561054352513 ↗
23. Residual stress development in adhesive joints subjected to thermal cycling10.1080/00218469808012250 ↗
24. Prediction of long term strength of adhesively bonded joints in sea water10.1016/j.ijadhadh.2009.02.013 ↗
25. 3D modeling of the behavior of an adhesive in an assembly using a non-associated elastoplastic pressure dependent model
26. Debonding failure characteristics of multi-laminated bonding system under cryogenic temperature10.1016/j.ijadhadh.2011.02.002 ↗
27. Numerical analysis of edge effects in adhesively-bonded assemblies. Application to the determination of the adhesive behaviour10.1016/j.compstruc.2008.02.003 ↗
28. ASTM D5656-95. Standard test method for thick-adherend metal lap-shear joints for determination of the stress–strain behavior of adhesives in shear by tension loading, ASTM, 1995.
29. A study of the non-linear behaviour of adhesively-bonded composite assemblies10.1016/j.compstruct.2006.06.006 ↗
30. Creep, recovery and relaxation of shear-loaded adhesive bondlines10.1177/073168448200100103 ↗
31. Optimisation of adhesively-bonded single lap joints by adherend notching10.1163/156856100742258 ↗
32. Analysis of the non linear behaviour of an adhesive in bonded assemblies under shear loadings. Proposal of an improved TAST10.1163/156856109X432956 ↗
33. Experimental analysis of the influence of hydrostatic stress on the behaviour of an adhesive using a pressure vessel10.1080/00218464.2011.597318 ↗
34. Epoxy resin developments for large superconducting magnet impregnation10.1016/S0011-2275(97)00104-5 ↗