The Role of Silicon in the Solidification of High-Cr Cast Irons

This work analyzes the effect of different additions of silicon (0 to 5.0 pct) on the structure of a high-Chromium white cast iron, with chromium content of 16.8 pct and carbon 2.56 pct. The alloys were analyzed in both as-cast and heat-treated conditions. Casting was undertaken in metallic molds that yielded solidification rates faster than in commercial processes. Nevertheless, there was some degree of segregation of silicon; this segregation resulted in a refinement in the microstructure of the alloy. Silicon also generated a greater influence on the structure by destabilizing the austenitic matrix, and promoted greater precipitation of eutectic carbides. Above 3 pct silicon, pearlite formation occurred in preference to martensite. After the destabilization heat treatment, the matrix structure of the irons up to 3 pct Si consisted of secondary carbides in a martensitic matrix with some retained austenite; higher Si additions produced a ferritic matrix. The different as-cast and heat-treated microstructures were correlated with selected mechanical properties such as hardness, matrix microhardness, and fracture toughness. Silicon additions increased matrix microhardness in the as-cast conditions, but the opposite phenomenon occurred in the heat-treated conditions. Microhardness decreased as silicon content was increased. Bulk hardness showed the same behavior. Fracture toughness was observed to increase up to 2 pct Si, and then decreased for higher silicon contents. These results are discussed in terms of the effect of eutectic carbides’ size and the resulting matrix due to the silicon additions.