Alternating polymers based on fluorinated alkoxyphenyl-substituted benzo[1,2-b:4,5-b′]dithiophene and isoindigo derivatives for polymer solar cells
Source abstract
Abstract
Abstract To effectively modulate the molecular energy levels of isoindigo-based polymers through side-chain modification on the donor segments, three alkoxyphenyl-modified benzo[1,2-b:4,5-b′]dithiophene (BDT) were synthesized and used as electronic-donor units, which were copolymerized with the electron-withdrawing segment 2-ethylhexyl-substituted isoindigo (IID) to construct donor-acceptor (D-A) polymers. The obtained three polymers are named as P-IID , m F-IID and o F-IID , which possess 4-(2-octyldodecaneoxy)-phenyl, 2-fluoro-4-(2-octyldodecaneoxy)-phenyl and 3-fluoro-4-(2-octyldodecaneoxy)-phenyl side-chains in the BDT unit, respectively. All polymers display broad absorption regions with the film absorption edges of 759 nm ( P-IID ), 742 nm ( m F-IID ) and 726 nm ( o F-IID ). The fluorination on the phenyl side-chains of BDT unit results in obvious blue-shift in the absorption spectra, especially for the ortho -position fluorinated polymer o F-IID because of the enlarged dihedral angles between the phenyl rings and the BDT backbones. Gradient reduction in the highest occupied molecular orbital (HOMO) energy levels are observed for the three polymers, with HOMO values of −5.35 eV for P-IID , −5.48 eV for m F-IID and −5.53 eV for o F-IID , separately. As the result of the HOMO energy levels, polymer solar cells (PSCs) with inverted device configuration by blending the polymers with [6,6]-phenyl-C71 butyric acid methyl ester (PC 71 BM) show continually increased open circuit voltage ( V oc ) from 0.84 V for P-IID to 0.88 V ( m F-IID ) and then a notable value of 0.96 V for o F-IID . However, the fluorination leads to intensively reduced short-circuit current density ( J sc ) of the PSCs, 9.68 mA cm −2 for P-IID , 5.61 mA cm −2 for m F-IID and a very low value of 1.61 mA cm −2 for o F-IID , respectively. Consequently, moderate power conversion efficiency (PCE) of 5.23% is achieved for the non-fluorinated polymer P-IID as well as a decreased value of 2.50% for the meta -fluorinated polymer and a very low PCE of 0.93% for the ortho -fluorinated polymer. These results imply that although fluorine substituted side-chain in the donor unit can effectively deepen the HOMO energy levels of the polymers to obtain enlarged V oc , the absorption losses of the fluorinations caused low J sc should be taken into consideration to design high efficient electron-donating alternating polymers for polymer solar cells.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Organic Electronics and Photovoltaics · Conducting polymers and applications · Perovskite Materials and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Polymer photovoltaic cells: enhanced efficiencies via a network of internal donor-acceptor heterojunctions10.1126/science.270.5243.1789 ↗
2. Bulk heterojunction solar cells with internal quantum efficiency approaching 100%10.1038/nphoton.2009.69 ↗
3. Molecular design of photovoltaic materials for polymer solar cells: toward suitable electronic energy levels and broad absorption10.1021/ar2002446 ↗
4. Molecular bulk heterojunctions: an emerging approach to organic solar cells10.1021/ar900041b ↗
5. High-performance polymer solar cells of an alternating polyfluorene copolymer and a fullerene derivative10.1002/adma.200304150 ↗
6. Design rules for donors in bulk-heterojunction solar cells—towards 10% energy-conversion efficiency10.1002/adma.200501717 ↗
7. High performance alternating polymers based on two-dimensional conjugated benzo[1,2-b:4,5-b']dithiophene and fluorinated dithienylbenzothiadiazole for solar cells10.1039/C6RA13595A ↗
8. Fluorine in crystal engineering-“the little atom that could”10.1039/B406892K ↗
9. Development of fluorinated benzothiadiazole as a structural unit for a polymer solar cell of 7% efficiency10.1002/anie.201005451 ↗
10. Single-junction polymer solar cells with high efficiency and photovoltage10.1038/nphoton.2015.6 ↗
11. Efficient organic solar cells processed from hydrocarbon solvents10.1038/nenergy.2015.27 ↗
12. Bandgap and molecular energy level control of conjugated polymer photovoltaic materials based on benzo[1,2-b:4,5-b′]dithiophene10.1021/ma800820r ↗
13. Molecular design of benzodithiophene-based organic photovoltaic materials10.1021/acs.chemrev.6b00176 ↗
14. New alkoxylphenyl substituted benzo[1,2-b:4,5-b'] dithiophene-based polymers: synthesis and application in solar cells10.1039/c3ta11968h ↗
15. Low-temperature, solution-processed, high-mobility polymer semiconductors for thin-film transistors10.1021/ja067879o ↗
16. A polybenzo[1,2-b:4,5-b′]dithiophene derivative with deep HOMO level and its application in high-performance polymer solar cells10.1002/anie.200906934 ↗
17. Molecular design toward highly efficient photovoltaic polymers based on two-dimensional conjugated benzodithiophene10.1021/ar5000743 ↗
18. Fullerene derivative-doped zinc oxide nanofilm as the cathode of inverted polymer solar cells with low-bandgap polymer (PTB7-Th) for high performance10.1002/adma.201301476 ↗
19. Systematic investigation of benzodithiophene- and diketopyrrolopyrrole-based low-bandgap polymers designed for single junction and tandem polymer solar cells10.1021/ja301460s ↗
20. Efficient polymer solar cells based on benzothiadiazole and alkylphenyl substituted benzodithiophene with a power conversion efficiency over 8%10.1002/adma.201301494 ↗
21. New polybenzo[1,2-b:4,5-b′]dithiophene derivative with an alkoxyphenyl side chain: applications in organic photovoltaic cells and organic semiconductors10.1016/j.solmat.2014.02.006 ↗
22. Incorporation of fluorine onto different positions of phenyl substituted benzo[1,2-b:4,5-b′]dithiophene unit: influence on photovoltaic properties10.1021/acs.macromol.5b00564 ↗
23. 4-Alkyl-3,5-difluorophenyl-Substituted benzodithiophene-based wide band gap polymers for high-efficiency polymer solar cells10.1021/acsami.5b08769 ↗
24. Novel donor-acceptor polymers containing o-fluoro-p-alkoxyphenyl-substituted benzo[1,2-b:4,5-b']dithiophene units for polymer solar cells with power conversion efficiency exceeding 9%10.1039/C6TA03709G ↗
25. Polymers from phenyl-substituted benzodithiophene and tetrafluoridequinoxaline with high open circuit voltage and high fill factor10.1016/j.orgel.2016.07.007 ↗
26. Recent developments on isoindigo-based conjugated polymers10.1039/C3PY01598J ↗
27. Ultrafast intramolecular exciton splitting dynamics in isolated low-band-gap polymers and their implications in photovoltaic materials design10.1021/ja209003y ↗
28. An isoindigo-based low band gap polymer for efficient polymer solar cells with high photo-voltage10.1039/c1cc11053e ↗
29. Dithienocarbazole and isoindigo based amorphous low bandgap conjugated polymers for efficient polymer solar cells10.1002/adma.201303586 ↗
30. An isoindigo and dithieno[3,2-b:2',3'-d]silole copolymer for polymer solar cells10.1039/C1PY00402F ↗
31. Synthesis and characterization of benzodithiophene-isoindigo polymers for solar cells10.1039/C1JM14940G ↗
32. A low bandgap polymer based on isoindigo and bis(dialkylthienyl)benzodithiophene for organic photovoltaic applications10.1002/pola.26275 ↗
33. Synthesis of isoindigo-based oligothiophenes for molecular bulk heterojunction solar cells10.1021/ol902512x ↗
34. Isoindigo-based Donor−Acceptor conjugated polymers10.1021/ma1018445 ↗
35. Inverted polymer solar cells integrated with a low-temperature-annealed sol-gel-derived ZnO film as an electron transport layer10.1002/adma.201004301 ↗
36. Enhanced power-conversion efficiency in polymer solar cells using an inverted device structure10.1038/nphoton.2012.190 ↗
37. Design, application, and morphology study of a new photovoltaic polymer with strong aggregation in solution state10.1021/ma301900h ↗
38. Synthesis and photovoltaic properties of two-dimensional conjugated polythiophenes with Bi(thienylenevinylene) side chains10.1021/ja060141m ↗
39. Positional effects of fluorination in conjugated side chains on photovoltaic properties of donor–acceptor copolymers10.1039/C6CC06646A ↗