journal article·2018-07

Low cost inorganic white light emitting diode based on submicron ZnO rod arrays and electrodeposited Cu2O thin film

Mahmoud Abdelfatah, Walid Ismail, Abdelhamid El-Shaer

Publisher page

Abstract

Abstract We present here the fabrication and characterization of low cost inorganic white light emitting diode (LED) based on submicron ZnO rod arrays and Cu2O thin film. Firstly, n-ZnO rod arrays were grown on FTO substrate by hydrothermal method at 150 °C. Then, p-Cu2O thin film was electrodeposited on top of ZnO arrays from alkaline cupric lactate solution at 60 °C. X-ray diffraction and scanning electron microscopy were employed to investigate the structural and the morphology of the prepared samples as well as the diode device. The results indicate the formation of hexagonal structure of ZnO arrays and cubic structure of polycrystalline Cu2O thin film. The performance of LED device was investigated employing I-V and electroluminescence measurements. The heterojunction device showed good rectification behavior and a broad emission covering visible spectrum for all applied voltage which indicates the white electroluminescence of the heterostructure device. Therefore, the inorganic ZnO arrays/Cu2O thin film is a promising heterojuniction for low cost and large-scale production of white LED.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: ZnO doping and properties · Copper-based nanomaterials and applications · Gas Sensing Nanomaterials and Sensors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. Synthesis of Ga-Doped ZnO nanorods by hydrothermal method and their application to ultraviolet photodetector10.3390/inventions1010003 ↗
2. Zinc oxide nanostructures: growth properties and applications10.1088/0953-8984/16/25/R01 ↗
3. Growth of ZnO nanorods on glass substrate by chemical bath deposition10.1016/j.mspro.2015.11.130 ↗
4. Dissolving behavior and stability of ZnO wires in biofluids: a study on biodegradability and biocompatibility of ZnO nanostructures10.1002/adma.200600200 ↗
5. Seed layer synthesis effect on the concentration of interface defects and emission spectra of ZnO nanorods/p‐GaN light‐emitting diode
6. White electroluminescence using ZnO nanotubes/GaN heterostructure light-emitting diode10.1007/s11671-010-9588-z ↗
7. n-ZnO nanorods/p+-Si (111) heterojunction light emitting diodes10.1186/1556-276X-7-664 ↗
8. Electroluminescence at 375 nm from a ZnO∕ GaN: mg∕ c-Al2O3 heterojunction light emitting diode
9. Effect of deposition parameters on electrodeposited cuprous oxide thin films
10. Effect of potentiostatic and galvanostatic electrodeposition modes on the basic parameters of solar cells based on Cu2O thin films10.1149/2.0191606jss ↗
11. Fabrication and characterization of flexible solar cell from electrodeposited Cu2O thin film on plastic substrate10.1016/j.solener.2015.11.002 ↗
12. One step to fabricate vertical submicron ZnO rod arrays by hydrothermal method without seed layer for optoelectronic devices10.1016/j.matlet.2017.09.064 ↗
13. Fabrication and characterization of low cost Cu2O/ZnO:Al solar cells for sustainable photovoltaics with earth abundant materials10.1016/j.solmat.2015.11.015 ↗
14. Fabrication of homojunction cuprous oxide solar cell by electrodeposition method
15. Studies on ZnO nanorods synthesized by hydrothermal method and their characterization
16. Hydrothermal growth of vertically aligned ZnO nanorods using a biocomposite seed layer of ZnO nanoparticles10.3390/ma6083584 ↗
17. Cu nanoparticles electrodeposited at liquid–liquid interfaces: a highly efficient catalyst for the hydrogen evolution reaction10.1002/chem.201406615 ↗
18. Size-controlled Cu2O nanocubes by pulse electrodeposition10.5229/JKES.2010.13.1.040 ↗
19. Potentiostatic deposition and characterization of cuprous oxide thin films10.1155/2013/271545 ↗