journal article·1991-11

Slab analysis of roll bonding of silver clad phosphor bronze sheets

Se-Hyeong Lee, Dong Nyung Lee

Materials Science and Technology· Volume 7· Issue 11
Publisher page

Abstract

A numerical analysis program, based on slab analysis, was developed to calculate the stresses and strains that occur in the component layers of a composite sheet in the roll bite during the fabrication of clad metal (e.g. silver clad phosphor bronze) by roll bonding. Results calculated using the perfect plastic and strain hardening models were compared with experimental results: the results obtained using the strain hardening model were found to be in better agreement with values of rolling force and thickness of component layers measured after roll bonding. The program requires input data such as roll radius, initial thickness of the specimen, initial cladding thickness fraction, reduction ratio, coefficients of friction between rolls and material and between component layers, and front and back tensions. The coefficients of friction were evaluated indirectly by comparison of the measured rolling force with that calculated using slab analysis. Measured coefficients of friction varied with reduction ratio and initial thickness, but were independent of rolling speed.MST/1334
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Metallurgy and Material Forming · Metal Forming Simulation Techniques · Metal Alloys Wear and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (16)

Show source-provided references
1. VAIDYANATH L. R. · Weld · 1959 · 1 · 13
2. TYLECOTE R. E · Br. Weld. J., · 1958 · 5 · 21
3. TYLECOTE R. F. · Br. Weld. J., · 1963 · 10 · 385
4. MILNER D. R. · Br. Weld. J., · 1961 · 8 · 375
5. H. SUZUKI, J. ARAKI, M. AIBA, K. SHINTANI, and M. FURUGEN: ‘Studies on deformation mechanism in rolling double layered metal sheets’, Report of the Institute of Industrial Science, Vol. 25, No. 2, 51; 1975, Tokyo, University of Tokyo.
6. 10.1243/PIME_PROC_1948_159_015_0210.1243/PIME_PROC_1948_159_015_02 ↗
7. w. L. ROBERTS: ‘Cold rolling of steel’, 494; 1978, New York, Marcel Dekker.
8. D. N. LEE: ‘Deformation processing’, 338; 1987, Seoul, Korea, Mun Woon Dang.
9. McEWAN K. J. B. · Br. Weld. J., · 1962 · 9 · 408
10. 10.1243/PIME_PROC_1955_169_024_0210.1243/PIME_PROC_1955_169_024_02 ↗
11. w. L. ROBERTS: ‘Cold rolling of steel’, 293; 1978, New York, Marcel Dekker.
12. R. L. BURDEN and J. D. FAIRES: ‘Numerical analysis’, 3 edn, 225; 1985, Boston, MA, Prindle, Weber and Schmidt.
13. R. W. HORNBECK: ‘Numerical methods’, 65; 1975, New York, Quantum.
14. D. N. LEE: ‘Deformation processing’, 336; 1987, Seoul, Korea, Mun Woon Dang.
15. w. L. ROBERTS: ‘Cold rolling of steel’, 495; 1978, New York, Marcel Dekker.
16. 10.1179/mst.1986.2.6.62010.1179/mst.1986.2.6.620 ↗