journal article·1991-02

Bending fatigue strength of carburising steel SS 2506

S. Preston

Publisher page

Abstract

AbstractAbstractThe effect of steel cleanness, core hardenability, and microstructure after carburising on bending fatigue strength is described for the standard steel grade SS 2506. Examination of the fatigue fracture surfaces revealed that initiation had occurred at the surface where an internally oxidised layer was present. Differences in the inclusion content were not a major cause of fatigue failure. The highest fatigue strength was obtained for the smallest grain size material, but the effect of grain size is small in comparison with the base composition. An explanation for the variation in fatigue strength between heats is given with reference to the difference in case depth and core hardenability, and their effect on the compressive residual stresses within the case. Optimum fatigue strength was achieved for the shortest case depth and a low core hardenability. The results indicate the importance of close control over these two parameters in producing the optimum fatigue strength.MST/1239
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Fatigue and fracture mechanics · Microstructure and Mechanical Properties of Steels · Metal Alloys Wear and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (13)

Show source-provided references
1. o. SANDBERG: ‘Influence of Ca treatment on fatigue properties of case hardening steel SS 2506’, Report IM-2114, Swedish Institute for Metals Research, 1986.
2. T. HILLSKOG and O. SANDBERG: ‘Relation between alloying content and mechanical properties of three low alloyed case hardening steels’, Report IM-2162, Swedish Institute for Metals Research, 1987.
3. S. PRESTON: ‘Evaluation of vanadium as a microalloying addition in a carburising steel’, Report IM-2395, Swedish Institute for Metals Research, 1988.
4. K. VELANDER, R. BLOM, and S. PRESTON: ‘Effect of continuous casting on the fatigue and fracture properties of the carburising steel SS 2506’, Report IM-2492, Swedish Institute for Metals Research, 1989.
5. D. B. CULLITY: ‘Elements of X-ray diffraction’, 391; 1959, London, Addison-Wesley.
6. S. PRESTON: ‘Literature survey on optimising the metallurgical and mechanical properties of case carburised components’, Report IM-2239, Swedish Institute for Metals Research, 1987.
7. CAMERON T. B. · J. Met., · 1983 · 35 · 37
8. 10.1007/BF0264857210.1007/BF02648572 ↗
9. KERN R. F. · Met. Prog., · 1972 · 102 · 53
10. 10.1179/03071698280328604310.1179/030716982803286043 ↗
11. M. LARSSON, B. JANSSON, R. BLOM, and A. MELANDER: ‘Influence of austenitising and quenching temperature on Jominy harden-ability of a case hardening and a boron steel’, Report IM-2440, Swedish Institute for Metals Research, 1988.
12. K. E. THELNING: ‘Steel and its heat treatment’, 169; 1984, London, Butterworths.
13. S. PRESTON and A. MELANDER: ‘Influence of silicon on the fatigue and fracture properties of carburised steels’, Report IM-2500, Swedish Institute for Metals Research, 1989.