Microstructure and mechanical characteristics of VT1-0 alloy after rapid surface heat treatment
Source abstract
Abstract
We study the distinctive features of the formation of microstructure and mechanical properties of VT1-0 commercially pure titanium subjected to rapid surface heat treatment. In a layer of the metal suffering the α → β → α transformation, we observe the formation of an α-structure with larger grain sizes and a somewhat lower microhardness, whereas in the transition zone, between the layers heated to temperatures above and below the temperature of the polymorphic transformation {ie368-01}, the microhardness increases. The increase in the volume fraction of the layer heated to a temperature above {ie368-02} is accompanied by a monotonic elevation of the strength properties and deterioration of the plastic characteristic of the metal. In the case of 100% heating above {ie368-03}, the fatigue limit of the metal becomes 1.5 times higher. On the basis of the accumulated results, we make a conclusion that the changes in the mechanical characteristics of the alloy are connected with the formation of thermal compression stresses caused by very rapid processes of heating and cooling of the metal (up to 400°C/sec).
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Nuclear Materials and Properties · Titanium Alloys Microstructure and Properties · Metal and Thin Film Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (6)
Show source-provided references
1. U. Zwicker, Titan und Titanlegierungen, Springer, Berlin-Heidelberg-New York (1974).10.1007/978-3-642-80587-5 ↗
2. G. Lutjering and J. C. Williams, Titanium, Springer-Verlag, Berlin-Heidelberg (2003).10.1007/978-3-540-71398-2 ↗
3. G. Lutjering, “Influence of processing on microstructure and mechanical properties of (α + β) titanium alloys,” Mat. Sci. Eng., A243, 32–45 (1998).10.1016/S0921-5093(97)00778-8 ↗
4. V. N. Gridnev, S. P. Oshkaderov, and O. M. Ivasishin, Physical Foundations of Rapid Thermal Hardening of Alloys [in Russian], Naukova Dumka, Kiev (1976)
5. O. M. Ivasishin and P. E. Markovsky, “Enhancing the mechanical properties of titanium alloys with rapid heat treatment (overview),” J. Mater., No. 7, 48–52 (1996).
6. P. E. Markovs'kyi, V. K. Pishchak, B. M. Mordyuk, and P. N. Okrainets', “Improvement of the fatigue characteristics of VT1-0 titanium alloy by the surface mechanical and rapid thermal treatment,” Fiz.-Khim. Mekh. Mater., 42, No. 3, 85–91 (2006).