Correlation Among the Input Thermal Parameters and Thermography Measurements Data of the Resistance Seam Welding
Source abstract
Abstract
Resistance Seam Welding (RSEW) is commonly used in continuous steel processing for joining steel coils. Experimental studies focused on the welding process quality controls are justified by their wide application and influence on the performance of steelmaking processes. The present study focuses on the continuous annealing line welding process using as sample, a low carbon steel (0.07%C) with 0.21 mm thickness. The work proposes a correlation of thermal input, electric current parameter and thermogram monitoring during RSEW procedures. A methodology was developed to determine the real thermal profiles values by means of association of the thermograms with the sample emissivity curve. Three heat input levels were used, 3.64 J.mm-1, 5.09 J.mm-1, and 6.38 J.mm-1, respectively, for typical C-Mn steel. The thermal welding profile obtained experimentally exhibited linear correlation coefficients (R) of 0.99 with the electric current welding parameter and (R) of 0.99 with the calculated thermal input, respectively. The welds metallurgical characterizations results, expressed through the ductility and welds nuggets analysis, were conducted to correlate the welds quality with the welding thermal input. The Erichsen cupping test showed that the higher the thermal input corresponds to higher ductility of the welds. Nevertheless, the heat input of 5.09 J.mm-1 indicated better-balanced properties: ductility, weld nugget discontinuity, nugget size, and no expulsion of the melt material.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Welding Techniques and Residual Stresses · Thermography and Photoacoustic Techniques · Microstructure and Mechanical Properties of Steels
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Universidade Federal Fluminense, Brasil; Companhia Siderúrgica Nacional, Brasil
Universidade Federal Fluminense, Brasil
Companhia Siderúrgica Nacional, Brasil
References (15)
Show source-provided references
1. Solid-state resistance seam welding of galvanized steel10.1007/s00170-015-8294-5 ↗
2. Algumas equações úteis em soldagem10.1590/S0104-92242014000100011 ↗
3. Nunes RM · 1993 · 6
4. Comparison of NDT-methods for automatic inspection of weld defects10.1504/IJMPT.2015.066863 ↗
5. Chen J · 2015 · 948513–1
6. Perin AL · 2009
7. Adaptive welding by fiber optic thermographic sensing: an analysis of thermal and instrumental considerations
8. Analysis of weld defects in similar and dissimilar resistance seam welding of aluminium, zinc and galvanised steel10.1179/1362171815Y.0000000031 ↗
9. Emissivity calibration for temperatures measurement using thermography in the context of machining10.1016/j.applthermaleng.2013.03.051 ↗
10. Effect of temperature-dependency of surface emissivity on heat transfer using the parameterized perturbation method10.2298/TSCI11S1123J ↗
11. Total hemispherical emittance of coated and uncoated inconel and types 321 and 430 stainless steel10.6028/jres.066C.022 ↗
12. Paloposki T · 2005 · 1
13. Deus VS · 2019
14. Palacíos AMG · 2010
15. Deus VS · 2018 · 338