journal article·2017-12-18Open access

Evaluation of Welding Parameter's Effects on Corrosion Behavior of Bronze-Carbon Steel Dual-Layer Explosion Welded Joint at Salt Enviroment

Mohammad Reza Khanzadeh Ghareh Shiran, Mohammad Razazi, Hamid Bakhtiari, Ali Tavira

Materials Research· Volume 21· Issue 2

Abstract

In the current investigation, corrosion behavior and microstructural variations of explosion-welded joint of bronze-carbon steel dual-layer plates were studied. The resultant curves of potentiodynamic's polarization tests demonstrated that the lowest corrosion rate was related to the sample with maximum explosive load thickness, and the highest corrosion speed was for the sample with minimum standoff distance. EIS test results of welded samples were indicative of creating a passive layer at the beginning of immersion process which showed that the polarization resistance has been reduced by increasing of explosive load thickness. So, the corrosion mechanism included two stages; at the beginning of immersion, for the samples with the lower thickness of explosive load, a passive layer would be created around the component due to higher concentration gradient and then, by removing of this layer, the galvanic couple determines the corrosion rate.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced Welding Techniques Analysis · Welding Techniques and Residual Stresses · Hydrogen embrittlement and corrosion behaviors in metals

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Islamic Azad University, Iran

References (13)

Show source-provided references
1. Crossland B · 1982
2. Blazynski TZ · 1983
3. Benák M
4. Effect of Stand-Off Distance on the Mechanical and Metallurgical Properties of Explosively Bonded 321 Austenitic Stainless Steel - 1230 Aluminum Alloy Tubes.10.1590/1980-5373-mr-2016-0516 ↗
5. Kengkla N
6. Corrosion and microstructural aspects of dissimilar joints of titanium and type 304L stainless steel10.1016/S0022-3115(03)00194-6 ↗
7. Electrical Corrosion, and Mechanical Properties of Aluminum-Copper Joints Produced by Explosive Welding10.1007/s11665-012-0203-6 ↗
8. Joining of titanium/stainless steel by explosive welding and effect on interface10.1016/j.jmatprotec.2005.06.045 ↗
9. Corrosion and mechanical-microstructural aspects of dissimilar joints of Ti-6Al-4V and Al plates10.1016/j.ijimpeng.2006.08.003 ↗
10. Comparison of corrosion behavior between fusion cladded and explosive cladded Inconel 625/plain carbon steel bimetal plates10.1016/j.matdes.2012.06.053 ↗
11. Novel deformation processes and microstructures involving ballistic penetrator formation and hypervelocity impact and penetration phenomena10.1016/S1044-5803(96)00173-8 ↗
12. Stansbury EE · 2000
13. Dissimilar welding behavior of 22% Cr series stainless steel with 316L and its corrosion resistance in modified aggressive environment10.1016/j.jmapro.2016.07.001 ↗