journal article·2012-11-02Open access

Effect of calcium content on the microstructure, hardness and in-vitro corrosion behavior of biodegradable Mg-Ca binary alloy

Shervin Eslami Harandi, Mohammad Mirshahi, Shahriar Koleini, Mohd Hasbullah Idris, Hassan Jafari, Mohammed Rafiq Abdul Kadir

Materials Research· Volume 16· Issue 1

Abstract

Effect of calcium addition on microstructure, hardness value and corrosion behavior of five different Mg-xCa binary alloys (x = 0.7, 1, 2, 3, 4 wt. (%)) was investigated. Notable refinement in microstructure of the alloy occurred with increasing calcium content. In addition, more uniform distribution of Mg2Ca phase was observed in a-Mg matrix resulted in an increase in hardness value. The in-vitro corrosion examination using Kokubo simulated body fluid showed that the addition of calcium shifted the fluid pH value to a higher level similar to those found in pure commercial Mg. The high pH value amplified the formation and growth of bone-like apatite. Higher percentage of Ca resulted in needle-shaped growth of the apatite. Electrochemical measurements in the same solution revealed that increasing Ca content led to higher corrosion rates due to the formation of more cathodic Mg2Ca precipitate in the microstructure. The results therefore suggested that Mg-0.7Ca with the minimum amount of Mg2Ca is a good candidate for bio-implant applications.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Hydrogen Storage and Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Universiti Teknologi Malaysia, Malaysia

Universiti Teknologi Malaysia, Malaysia; Shahid Rajaee University

References (26)

Show source-provided references
1. Biodegradable surgical implants based on magnesium alloys- a review of current research IOP Conf
2. In vitro degradation and mechanical integrity of Mg-Zn-Ca alloy coated with Xa-deficient hydroxyapatite by the pulse electrodeposition process
3. Progress and challenge for magnesium alloys as biomaterials10.1002/adem.200800035 ↗
4. Influence of hot rolling parameters on microstructure and biodegradability of Mg-1Ca alloy in simulated body fluid10.1016/j.matdes.2011.06.063 ↗
5. Magnesium and its alloys as degradable biomaterials, Corrosion studies using potentiodynamic and EIS electrochemical techniques10.1590/S1516-14392007000100003 ↗
6. Influence of Ca on the corrosion properties of magnesium for biomaterials10.1016/j.matlet.2008.06.028 ↗
7. Research on an Mg-Zn alloy as a biodegradable biomaterial10.1016/j.actbio.2009.06.028 ↗
8. In vivo corrosion of four magnesium alloys and the associated bone response10.1016/j.biomaterials.2004.09.049 ↗
9. In vitro and in vivo corrosion measurements of magnesium alloys10.1016/j.biomaterials.2005.07.037 ↗
10. Neuropathology of aluminum toxicity in rats (glutamate and GABA impairment)10.1016/S1043-6618(02)00336-5 ↗
11. Differences in behavior among the chlorides of seven rare earth elements administered intravenously to rats10.1006/faat.1997.2322 ↗
12. In vivo corrosion behavior of Mg-Mn-Zn alloy for bone implant application
13. The development of binary Mg-Ca alloys for use as biodegradable materials within bone10.1016/j.biomaterials.2007.12.021 ↗
14. Effect of galvanic corrosion between precipitate and matrix on corrosion behavior of as-cast magnesium-aluminum alloys10.1007/BF03028082 ↗
15. Surface integrity of biodegradable Magnesium-Calcium orthopedic implant by burnishing10.1016/j.jmbbm.2011.06.006 ↗
16. Using a synthetic body fluid (SBF) solution of 27 mM HCO3- to make bone substitutes more Osteointegrative10.1016/j.msec.2007.10.058 ↗
17. Superplasticity of the Mg-Ca eutectic alloy10.1007/BF00720076 ↗
18. In vitro corrosion resistance and cytocompatibility of nano-hydroxyapatite reinforced Mg-Zn-Zr composites
19. Biodegradable behaviors of AZ31 magnesium alloy in simulated body fluid10.1016/j.msec.2008.08.026 ↗
20. Corrosion of, and cellular responses to Mg-Zn-Ca bulk metallic glasses10.1016/j.biomaterials.2009.11.015 ↗
21. Corrosion behaviour of magnesium/aluminium alloys in 3.5 wt.% NaCl10.1016/j.corsci.2007.11.005 ↗
22. Microstructure, mechanical properties and bio-corrosion properties of Mg-Zn-Mn-Ca alloy for biomedical application10.1016/j.msea.2008.06.019 ↗
23. The mechanism of biomineralization of bone-like apatite on synthetic hydroxyapatite: an in vitro assessment10.1098/rsif.2004.0003 ↗
24. Growth mechanism of hydroxyapatite-coatings formed on pure magnesium and corrosion behavior of the coated magnesium10.1016/j.apsusc.2011.04.087 ↗
25. Effect of forging process on microstructure, mechanical and corrosion properties of biodegradable Mg-1Ca alloy10.1016/j.matdes.2011.01.042 ↗
26. Microstructure, mechanical properties and bio-corrosion properties of Mg-Si(-Ca, Zn) alloy for biomedical application10.1016/j.actbio.2009.11.024 ↗