An investigation into the dissolution characteristics of γ precipitates in Mg-3Al-Zn alloy
Source abstract
Abstract
In non-equilibrium conditions, the coring phenomena may occur in the α-Mg solid solution and γ-Mg17Al12 phase forms in the microstructure of AZ magnesium alloy series. This eutectic phase may introduce detrimental effect on workability of wrought alloys. In the present work, the dissolution characteristics of γ phase have been investigated in AZ31 wrought magnesium alloy. Considering the eutectic temperature of AZ31 alloy, the homogenization treatment was executed in temperature range of 300-437 ºC (i.e., somewhat below eutectic melting temperature of γ precipitate) and 437-500 ºC (i.e., higher eutectic melting temperature of γ precipitate) for different durations. A thorough microstructural investigation and also thermodynamic calculations were executed. The results indicated that the dissolution rate of γ phase is very low even at temperatures just below the eutectic point of the alloy, whereas it dramatically increases at temperatures higher than eutectic point. Moreover, it is suggested that partial melting of γ phase due to eutectic melting reaction (α+γ→L) may lead to reduced formability.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Islamic Azad University, Iran
Azad University of Isfahan, Iran
University of Alberta, Canada
References (23)
Show source-provided references
1. Influence of Mg17Al12 intermetallic compounds on the hot extruded microstructures and mechanical properties of Mg-9Al-1Zn alloy10.1016/j.msea.2007.02.029 ↗
2. Effects of Homogenization Treatment on Mechanical Properties of Hot-Rolled AZ31 Magnesium Alloy
3. Constitutive modeling for the dynamic recrystallization evolution of AZ80 magnesium alloy based on stress-strain data10.1016/j.msea.2011.07.064 ↗
4. Analysis of high-temperature deformation and microstructure of an AZ31 magnesium alloy10.1016/j.msea.2006.03.155 ↗
5. Dynamic recrystallization during high temperature deformation of magnesium10.1016/j.msea.2008.02.004 ↗
6. Formability of AZ31 magnesium alloy sheets at warm working conditions10.1016/j.ijmachtools.2006.01.014 ↗
7. Processing maps for hot deformation of rolled AZ31 magnesium alloy plate: anisotropy of hot workability10.1016/j.msea.2007.10.038 ↗
8. Incipient melting in partially melted zone during arc welding of AZ91D magnesium alloy10.1016/j.msea.2005.10.032 ↗
9. Fracture behavior of AZ91 magnesium alloy10.1016/S0167-577X(00)00041-0 ↗
10. Effect of second phase on the mechanical properties of Mg-Al-Zn alloy by equal channel angular extrusion
11. Liquidus and solidus temperatures of Mg-rich Mg-Al-Mn-Zn alloys10.1016/j.actamat.2006.04.022 ↗
12. Brooks CR · 1982
13. Phase equilibria and solidification of Mg-rich Mg-Al-Zn alloys10.1016/j.msea.2006.02.006 ↗
14. Near-liquidus molding of Mg-Al and Mg-Al-Zn alloys10.1016/j.actamat.2005.01.009 ↗
15. Effect of semi-solid isothermal heat treatment on the microstructure of Mg-6A1-1Zn-0.7Si alloy10.1016/j.jmatprotec.2007.12.041 ↗
16. Solidification curves for commercial Mg alloys determined from differential scanning calorimetry with improved heat-transfer modeling10.1007/s11661-007-9237-z ↗
17. Development of the as-cast microstructure in magnesium-aluminium alloys10.1016/S1471-5317(00)00007-9 ↗
18. Reed-Hill RE · 1964
19. Cracking in the stir zones of Mg-alloy friction stir spot welds10.1007/s10853-007-1662-2 ↗
20. Superplasticity of coarse-grained magnesium alloy10.1016/S1359-6462(01)01234-9 ↗
21. Twinning, dynamic recovery and recrystallization in hot worked Mg-Al-Zn alloy10.1016/S0921-5093(02)00007-2 ↗
22. Effect of liquid phases on the tensile elongation of superplastic aluminum alloys and composites10.1016/0956-716X(94)00003-Z ↗
23. An investigation of compressive deformation behaviour for AZ91 Mg alloy containing a small volume of liquid10.1016/S1359-6454(03)00162-9 ↗