Electrolytic Deposition of Ni/NiO on Stainless Steel for Production of Selective Surfaces
Source abstract
Abstract
The solar energy is one of the most promising energy sources today. In this context, the goal of this work is to produce selective surfaces for receiver tubes of parabolic trough collectors (PTCs). Ideally, solar collectors should have an absorbing surface that has high absorptance for radiation in the solar energy spectrum and, at the same time, low emittance. Therefore, Ni/NiO selective surfaces were produced with Ni in the first film and NiO in the second film. The method used was by electrolytic deposition of nickel on stainless steel AISI 304, followed by oxidation in a muffle furnace. The thicknesses of the coatings were measured with the photometer Digimess, making it possible to verify their variations and the surface irregularities typical of the electrodeposition procedure. The NiO film was observed in scanning electron microscope (SEM). The film hardness was evaluated by the pencil hardness test and the adhesion by the tape test.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Solar Thermal and Photovoltaic Systems · Photovoltaic System Optimization Techniques · TiO2 Photocatalysis and Solar Cells
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Centro Federal de Educação Tecnológica de Minas Gerais, Brasil
Universidade de São Paulo, Brasil
References (23)
Show source-provided references
1. Selective surfaces of black chromium for use in solar absorbers
2. Development of an Al2O3-Co selective absorber for solar collectors10.1016/0040-6090(89)90113-2 ↗
3. Solar absorptance of copper-cobalt oxide thin film coating with nano-size, grain-like morphology: Optimization and synchrotron radiation XPS studies10.1016/j.apsusc.2013.01.081 ↗
4. An investigation on the performance characteristics of solar flat plate collector with diferente selective surface coatings
5. Callister WD · 2008
6. Martins M · 2010
7. Optical characterization of TiAlN/TiAlON/SiO2 absorber for solar selective applications10.1016/j.surfcoat.2011.09.003 ↗
8. Kennedy CE · 2002
9. Krenzinger A · 1979
10. A facile process to prepare copper oxide thin films as solar selective absorbers10.1016/j.apsusc.2011.07.088 ↗
11. Evaluation of potential residual silica as antireflective layer for selective solar surface of black chromium
12. Novel sol-gel based selective coatings: from coil absorber coating to high power coating10.1016/j.solmat.2015.04.010 ↗
13. Optical design and co-sputtering preparation of high performance Mo-SiO2 cermet solar selective absorbing coating10.1016/j.apsusc.2013.04.142 ↗
14. 2007
15. Optimization of metal sputtered and electroplated substrates for solar selective coating10.1016/j.renene.2007.06.025 ↗
16. 2014
17. Peixoto CS · 2018
18. Electrochemical deposition of black nickel solar absorber coatings on stainless steel AISI316L for thermal solar cells10.1016/j.solmat.2004.07.045 ↗
19. Teixeira R · 2011
20. Produção de superfícies seletivas de Ni/NiO por processos químico e eletrolítico em substrato de alumínio
21. 2005
22. 2004
23. Sade W · 2011