journal article·2013-11-08Open access

Processing of a LLDPE/HDPE pressure vessel liner by rotomolding

E. S. Barboza Neto, L. A. F. Coelho, M. M. C. Forte, S. C. Amico, C. A. Ferreira

Materials Research· Volume 17· Issue 1

Abstract

Biaxial rotational molding is a low-pressure process that uses a polymer powder to produce large and/or complex-shaped hollow thermoplastic goods using low cost molds, being very suitable for prototype production. In the present work, liner prototypes (F 78 × 280 mm) made of linear low density (LLDPE) and high density polyethylene (HDPE) blends were produced aiming to later use them as compressed natural gas type IV cylinders. The LLDPE/HDPE blend composition and the process parameters (temperature/time cycle, and rotation speed) were varied to evaluate their effect on blend miscibility and liner final properties, such as density and crystallization behavior. Blend composition and process parameters were found vital for the production of a homogeneous wall and for the liner to reach adequate characteristics for the intended product.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Polymer Foaming and Composites · Material Properties and Processing · Polymer crystallization and properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Universidade Federal do Rio Grande do Sul, Brasil

Universidade do Estado de Santa Catarina, Brasil

References (18)

Show source-provided references
1. 2000
2. Simulation of non-isothermal melt densification of polyethylene in rotational molding10.1002/pen.10942 ↗
3. Development of a new generation of filament wound composite pressure cylinders10.1016/j.compscitech.2008.09.018 ↗
4. Barboza ES · 2009
5. Study on process and impact strength for a rotationally molded truck fender10.1016/j.jmatprotec.2006.11.142 ↗
6. Melting and densification of thermoplastics powders10.1002/pen.10718 ↗
7. Effect of enhancing fins on the heating/cooling efficiency of rotational molding and the molded product qualities10.1016/j.polymertesting.2007.10.004 ↗
8. Bubble removal in rotational molding10.1002/pen.20035 ↗
9. Prediction of the remaining lifetime of polyethylene pipes after up to 30 years in use10.1016/j.polymertesting.2009.06.004 ↗
10. Optimisation of rotational moulding of polyethylene by predicting antioxidant consumption10.1016/S0141-3910(01)00234-8 ↗
11. Phase behavior of poly(3-hydroxybutyrate)/poly (3-hydroxybutyrate-co-3-hydroxyvalerate) blends10.1016/j.fluid.2007.07.022 ↗
12. Linear Low Density Polyethylene Thermal Fractionation by DSC Technique10.1080/10236660701802593 ↗
13. Polyethylene blends: A correlation study between morphology and environmental resistance10.1016/j.polymdegradstab.2007.10.017 ↗
14. Unique crystal morphology and tensile properties of injection-molded bar of LLDPE by adding HDPE with different molecular weights10.1016/j.actamat.2007.09.008 ↗
15. Phase behavior of semicrystalline polymer blends10.1016/j.polymer.2004.03.089 ↗
16. Canevarolo SV · 2004
17. 2004
18. 2010