Effects of Oxygen Flow Rates on the Physical Characteristics of Magnetron Sputtered Single-Phase Polycrystalline Cu2O Films
Source abstract
Abstract
The single-phase polycrystalline copper oxide (Cu2O) films were prepared on sapphire substrates by radio frequency (RF) magnetron sputtering technology which was characterized by low cost and high efficiency. The influences of oxygen flow rate on physical characteristics of the prepared films were investigated. The XRD results showed that the single-phase Cu2O film exhibited a (110) preferred orientation through the analysis of texture coefficient. The AFM images exhibited that the prepared Cu2O film had the highest surface roughness with a distinctive quadrangular surface morphology. The optical transmittance of the single-phase Cu2O film was under 35% and the band gap energy was calculated to be 2.30 eV, the absorption spectra included the peak wavelength of solar radiation and the high absorptivity made it to be a suitable absorbing material. The Hall measurement indicated that all the samples exhibited p-type conductivity. The resistivity, mobility and carrier concentration of the single-phase Cu2O film was 4625 Ω·cm, 1.87 cm2/v·s and 7.227×1014 cm−3, respectively.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Copper-based nanomaterials and applications · ZnO doping and properties · Electronic and Structural Properties of Oxides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Henan University of Science and Technology, China
Jilin University, China
References (43)
Show source-provided references
1. Tunability of CuOx properties by gas flow rate control in the reactive DC magnetron sputtering
2. Air-stable all inorganic green perovskite light emitting diodes based on ZnO/ CsPbBr3/NiO heterojunction structure10.1016/j.ceramint.2017.12.048 ↗
3. Nickel flux induced effects on structural and optical properties of NiO films fabricated by PA-MOCVD10.1016/j.vacuum.2015.04.034 ↗
4. Near infrared electroluminescence from p-NiO/n-InN/n-GaN light-emitting diode fabricated by PAMBE10.1016/j.jlumin.2017.02.053 ↗
5. High-efficiency and air-stable perovskite quantum dots light-emitting diodes with an all-inorganic heterostructure10.1021/acs.nanolett.6b04116 ↗
6. Ultraviolet electroluminescence properties from devices based on n-ZnO/i-NiO/p-Si light-emittingdiode10.1016/j.optcom.2016.01.071 ↗
7. Thickness dependent optical, structural, morphological, photocatalytic and catalytic properties of radio frequency magnetron sputtered nanostructured Cu2O–CuO thin films10.1016/j.ceramint.2020.03.017 ↗
8. Hierarchical TiO2:Cu2O Nanostructures for Gas/Vapor Sensing and CO2 Sequestration10.1021/acsami.9b18824 ↗
9. Heterojunction solar cell with 2% efficiency based on a Cu2O substrate10.1063/1.2194315 ↗
10. on-equilibrium alloying controls optoelectronic properties in Cu2O thin films for photovoltaic absorber applications10.1063/1.4914974 ↗
11. Controllable fabrication of Cu2O porous nanostructured films by negative bias deposition method10.1360/N972016-00928 ↗
12. A review on the role of materials science in solar cells10.1016/j.rser.2012.06.004 ↗
13. Characterization of Cu2O thin films prepared by evaporation of CuO powder10.1088/1742-6596/350/1/012027 ↗
14. Fabrication and characterization of Cu2O, ZnO and ITO thin films toward oxide thin film solar cell by mist chemical vapor deposition method10.1002/pssc.201300638 ↗
15. Effect of annealing on the electrodeposited Cu2O films for photoelectrochemical hydrogen generation10.1016/j.tsf.2010.04.073 ↗
16. Sol–gel deposited Cu2O and CuO thin films for photocatalytic water splitting10.1039/C4CP03241A ↗
17. Characteristics of electron beam evaporated and electrodeposited Cu2O thin films - comparative study10.1016/S1452-3981(23)17994-6 ↗
18. Germanium/perovskite heterostructure for high-performance and broadband photodetector from visible to infrared telecommunication band10.1038/s41377-019-0218-y ↗
19. Multilayer Graphene–GeSn Quantum Well Heterostructure SWIR Light Source10.1002/smll.201704414 ↗
20. Cuprous oxide (Cu2O) thin films prepared by reactive d.c. sputtering technique10.1016/j.vacuum.2017.04.033 ↗
21. Influence of growth temperature on structure, optical and electrical properties of nickel oxide films by magnetron sputtering10.1016/j.vacuum.2018.02.026 ↗
22. Effect of N doping on hole density of Cu2O: N films prepared by the reactive magnetron sputtering method10.1051/epjap/2012120020 ↗
23. Structural, surface morphological, and optical properties of nanocrystalline Cu2O and CuO films formed by RF magnetron sputtering: Oxygen partial pressure effect10.1002/pssa.201127627 ↗
24. Growth behavior and optical properties of N-doped Cu2O films10.1016/j.tsf.2011.07.037 ↗
25. Cu2O porous nanostructured films fabricated by positive bias sputtering deposition
26. Modifying the nanocrystalline characteristics—structure, size, and surface states of copper oxide thin films by high-energy heavy-ion irradiation10.1063/1.1499752 ↗
27. Cu2O thin films deposited by reactive direct current magnetron sputtering10.1016/j.tsf.2009.02.127 ↗
28. Structural, Optical and Electrical Properties of Polycrystalline CuO Thin Films Prepared by Magnetron Sputtering10.1007/s11664-018-6525-x ↗
29. X-ray studies of SnO2 prepared by chemical vapor deposition10.1016/0040-6090(86)90356-1 ↗
30. Plasticity induced texture development in thick polycrystalline CdTe: Experiments and modeling10.1063/1.2895382 ↗
31. Dependence of film texture on substrate and growth conditions for CdTe films deposited by close-spaced sublimation
32. Cu2O thin films deposited by reactive direct current magnetron sputtering10.1016/j.tsf.2009.02.127 ↗
33. Thin-Film Deposition of Cu2O by Reactive Radio-Frequency Magnetron Sputtering10.1143/JJAP.39.L786 ↗
34. The n-type conduction of indium-doped Cu2O thin films fabricated by direct current magnetron co-sputtering
35. Effects of oxygen flow rates on the physical characteristics of magnetron sputtered CuO films
36. Copper doped nickel oxide transparent p-type conductive thin films deposited by pulsed plasma deposition10.1016/j.tsf.2010.12.009 ↗
37. Optical Properties and Electronic Structure of Amorphous Germanium
38. The structure and properties of copper oxide and copper aluminium oxide coatings prepared by pulsed magnetron sputtering of powder targets10.1016/j.vacuum.2005.03.011 ↗
39. An effect of temperature on structural, optical, photoluminescence and electrical properties of copper oxide thin films deposited by nebulizer spray pyrolysis technique10.1016/j.mssp.2017.10.023 ↗
40. Optical and structural properties of nanocrystalline copper oxide thin films prepared by activated reactive evaporation10.1016/S0040-6090(01)01216-0 ↗
41. Preparation and characterization of quantum-size titanium dioxide10.1021/j100329a027 ↗
42. Epitaxial growth of high mobility Cu2O thin films and application to p-channel thin film transistor10.1063/1.3026539 ↗
43. Effect of Post Annealing on the Properties of Copper Oxide Thin Films Obtained from the Oxidation of Evaporated Metallic Copper10.1016/j.apsusc.2007.12.019 ↗