Effects of Friction Surfacing on the Characteristics of Consumable Rods of Ti-6Al-4V
Source abstract
Abstract
Friction surfacing (FS) is a coating technique applied mainly in corrosion protection and repair of components. The study addresses the effects of deposition and rotational speeds on the rods characteristics and process efficiency for the deposition of Ti-6Al-4V on self-mating substrates by FS. The consumption rate was 1.8 mm/s, deposition speeds of 8, 16 and 24 mm/s and rotational speeds of 2000, 3000 and 4000 rpm. It was shown that the flash forms primarily at the rod, ascending around the tip and leaving the coating without flash. The higher deposition speeds led to a decrease in rod thickness and diameter. For higher rotational speeds, an increase in diameter and decrease in thickness is observed for the flash on the rod. Experiments have shown that the rotational and deposition speeds have a decisive influence on the flash formation. Its microstructure changes due to the welding process and a change in hardness can be observed.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced Welding Techniques Analysis · Metal Alloys Wear and Properties · Welding Techniques and Residual Stresses
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Universidade Federal de Pernambuco, Brasil
Helmholtz-Zentrum Geesthacht GmbH, Germany
References (15)
Show source-provided references
1. Friction surfacing of Ti-6Al-4V: process characteristics and deposition behaviour at various rotational speeds10.1016/j.surfcoat.2015.07.039 ↗
2. On the characteristics of the rotational contact plane - a fundamental study of friction surfacing10.1080/09507119609549043 ↗
3. Hanke S · 2014
4. Comparative study of severe plastic deformation at elevated temperatures of two aluminium alloys during friction surfacing10.1016/j.jmatprotec.2017.04.021 ↗
5. Performance analysis of friction surfacing10.1016/j.jmatprotec.2012.03.013 ↗
6. Underwater friction surfacing10.1179/026708400322911483 ↗
7. Influence of rotational speed in the friction surfacing of titanium grade 1 on Ti-6Al-4V10.1590/1980-5373-mr-2016-1011 ↗
8. The role of process temperature and rotational speed in the microstructure evolution of Ti-6Al-4V friction surfacing coatings10.1016/j.matdes.2016.07.132 ↗
9. Vale N · 2016
10. A method for the in-situ study of solid-state joining techniques using synchrotron radiation - observation of phase transformations in Ti-6Al-4V after friction surfacing10.1016/j.surfcoat.2017.12.049 ↗
11. Influence of process parameters in the friction surfacing of AA 6082-T6 over AA 2024-T310.1016/j.procir.2013.05.058 ↗
12. Friction stir welding in HSLA-65 steel: Part I. Influence of weld speed and tool material on microstructural development10.1007/s11661-012-1110-z ↗
13. Friction surfacing-a review10.1016/j.jmatprotec.2013.12.008 ↗
14. Microstructural evolution during friction surfacing of tool steel H1310.1016/j.matdes.2010.06.031 ↗
15. Cavitation erosion of Cr60Ni40 coatings generated by friction surfacing10.1016/j.wear.2012.11.016 ↗