journal article·2018-11-08Open access

Effect of Experimental Parameters on Wear Response of Thermally Sprayed Carbide Based Coatings

Nitesh Vashishtha, Sanjay Sapate

Materials Research· Volume 22· Issue 1

Abstract

Friction and abrasive wear response of WC-12 Co and Cr3C2-25 NiCr coatings was studied. Abrasive wear experiments were conducted with SiC abrasive particles with varying load and sliding speeds. The results were analyzed using SEM, XRD and XPS observations of worn surfaces, wear debris and worn out abrasive paper. Friction coefficient diminished with rise in sliding speed and increased for increase in load while wear rates decreased for increasing sliding speed for both coatings. WC-12 Co coating had better wear resistance than Cr3C2-25 NiCr coating while Cr3C2-25 NiCr coating displayed lower friction coefficient. The variation in wear rate and friction response of coatings was due to combined effects of adhesion, abrasion and tribo oxidation effects. The composition of tribo films was strongly influenced by load and sliding velocity and altered friction and wear response of the coatings.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced materials and composites · Metal and Thin Film Mechanics · Metal Alloys Wear and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Visvesvaraya National Institute of Technology, India

References (69)

Show source-provided references
1. Tribology of thermal sprayed WC-Co coatings10.1016/j.ijrmhm.2009.07.011 ↗
2. HVOF coatings as an alternative to hard chrome for pistons and valves10.1016/j.wear.2005.12.005 ↗
3. Sapate SG · 2015 · 193
4. Influence of WC carbide particle size on the microstructure and abrasive wear behavior of WC-10Co-4Cr coatings for aircraft landing gear10.1016/j.wear.2016.05.022 ↗
5. Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials10.1016/j.wear.2011.11.008 ↗
6. Abrasive wear behaviour of detonation sprayed WC-Co coatings on mild steel10.1179/026708499101516470 ↗
7. Combating severe fluid erosion and corrosion of drill bits using thermal spray coatings10.1016/0043-1648(95)07142-3 ↗
8. Parametric study of abrasive wear of Co-CrC based flame sprayed coatings by Response Surface Methodology10.1016/j.triboint.2014.03.004 ↗
9. Tribological behaviour of HVOF sprayed WC-12Co, WC-10Co-4Cr and Cr3C2-25NiCr coatings10.1016/j.triboint.2016.09.025 ↗
10. Abrasive wear behavior of detonation sprayed WC-12Co coatings Influence of decarburization and abrasive characteristics10.1016/j.wear.2010.02.013 ↗
11. Effect of heat treatment on friction and abrasive wear behaviour of WC-12Co and Cr3C2-25NiCr coatings10.1016/j.triboint.2017.10.017 ↗
12. Engineering HVOF-Sprayed Cr3C2-NiCr Coatings: The Effect of Particle Morphology and Spraying Parameters on the Microstructure, Properties, and High Temperature Wear Performance10.1007/s11666-012-9833-3 ↗
13. Influence of heat treatment on the abrasive wear behaviour of HVOF sprayed WC-Co coatings10.1016/S0257-8972(98)00444-7 ↗
14. Comparative study of the dry sliding wear behaviour of HVOF-sprayed WC-(W,Cr)2C-Ni and WC-CoCr hardmetal coatings10.1016/j.wear.2013.11.001 ↗
15. Tribological behaviour at various temperatures of WC-Co coatings prepared using different thermal spraying techniques10.1016/j.triboint.2016.08.025 ↗
16. Study of the influence of microstructural properties on the sliding-wear behavior of HVOF and HVAF sprayed WC-cermet coatings10.1361/105996399770350656 ↗
17. Abrasive wear behaviour of WC-CoCr and Cr3C2-20(NiCr) deposited by HVOF and detonation spray processes10.1016/j.surfcoat.2004.10.136 ↗
18. Tribology of HVOF- and HVAF-sprayed WC-10Co4Cr hardmetal coatings A comparative assessment10.1016/j.surfcoat.2015.01.048 ↗
19. Abrasive wear maps for High Velocity Oxy Fuel (HVOF) sprayed WC-12Co and Cr3C2-25NiCr coatings10.1016/j.triboint.2017.04.037 ↗
20. Sliding wear behaviour of HVOF sprayed WC-Co coatings deposited with both gas fuelled and liquid fuelled systems10.1016/S0043-1648(03)00293-X ↗
21. Role of heat treatments in the improvement of the sliding wear properties of Cr3C2-NiCr coatings10.1016/S0257-8972(02)00148-2 ↗
22. Effects of carbide size and Co content on the microstructure and mechanical properties of HVOF-sprayed WC-Co coatings10.1016/j.surfcoat.2007.06.026 ↗
23. Abrasive wear behaviour of conventional and nanocomposite HVOF-sprayed WC-Co coatings10.1016/S0043-1648(99)00032-0 ↗
24. Effect of Carbide Grain Size on the Sliding and Abrasive Wear Behavior of Thermally Sprayed WC-Co Coatings10.1080/10402009708983682 ↗
25. Improvement on mechanical properties and wear resistance of HVOF sprayed WC-12Co coatings by optimizing feedstock structure10.1016/j.apsusc.2014.09.081 ↗
26. Optimizing HVOF spray process parameters to attain minimum porosity and maximum hardness in WC-10Co-4Cr coatings10.1016/j.surfcoat.2014.03.022 ↗
27. Effect of oxygen/fuel ratio on the in-flight particle parameters and properties of HVOF WC-CoCr coatings10.1016/j.surfcoat.2011.03.129 ↗
28. Effect of atmosphere, temperature and carbide size on the sliding friction of self-mated HVOF WC-CoCr contacts10.1016/j.triboint.2016.04.032 ↗
29. Effect of carbide grain size on microstructure and sliding wear behavior of HVOF-sprayed WC-12% Co coatings10.1016/S0043-1648(02)00294-6 ↗
30. Comparative evaluation of ambient temperature friction behaviour of thermal sprayed Cr3C2-25(Ni20Cr) coatings with conventional and nano-crystalline grains10.1016/j.triboint.2004.11.009 ↗
31. A critical review of tribocorrosion of cemented and thermal sprayed tungsten carbide10.1016/j.triboint.2017.10.006 ↗
32. Wear mechanisms in abrasion and erosion of WC/Co and related hardmetals10.1016/j.wear.2006.12.046 ↗
33. Binder extrusion in sliding wear of WC-Co alloys10.1016/0043-1648(85)90071-7 ↗
34. Sliding wear behaviour of WC-12%Co coatings at elevated temperatures10.1016/j.surfcoat.2004.12.032 ↗
35. Tribofilm formation on cemented carbides in dry sliding conformal contact10.1016/S0043-1648(00)00315-X ↗
36. Sliding wear behavior of thermally sprayed 75/25 Cr3C2/NiCr wear resistant Coatings10.1016/0043-1648(96)06983-9 ↗
37. Wear of thermally spray deposited low carbon steel coatings on aluminum alloys10.1016/S0043-1648(01)00718-9 ↗
38. Fabrication and tribological properties of WC-TiB2 composite cutting tool materials under dry sliding condition10.1016/j.triboint.2016.12.029 ↗
39. Effect of Tribo-Oxidation on Friction and Wear Behaviour of HVOF Sprayed WC-10Co-4Cr Coating10.1007/s11249-018-1006-1 ↗
40. Hutchings IM · 1992
41. Microstructure evolution and abrasive wear behaviour of D2 steel10.1016/j.wear.2015.02.019 ↗
42. Effect of abrasive particle size on wear resistance in steels10.1016/j.matdes.2004.10.010 ↗
43. Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact Effect of Abrasive Particle Size10.1080/10402004.2014.955229 ↗
44. Effect of hardness, microstructure, normal load and abrasive size on friction and on wear behaviour of 35NCD16 steel10.1016/j.wear.2017.05.008 ↗
45. Effect of particle characteristics on the two-body abrasive wear behaviour of a pearlitic steel10.1016/j.wear.2016.03.001 ↗
46. Friction and dry sliding wear behaviour of cermets10.1016/j.wear.2005.04.006 ↗
47. Two-body abrasive wear of nano- and microcrystalline TiC-Ni-based thermal spray coatings10.1016/j.surfcoat.2005.05.007 ↗
48. An investigation of sliding wear behaviour of WC-Co coating10.1016/j.triboint.2011.06.021 ↗
49. Nicholls JR · 2012
50. Friction and abrasive wear behaviour of Al2O3-13TiO2 and Al2O3-13TiO2-Ni Graphite coatings10.1016/j.triboint.2018.01.067 ↗
51. A study of the wear mechanism of diamond-like carbon films10.1016/0257-8972(95)02623-1 ↗
52. Formation and wear mechanisms of tribo-oxides and the regime of oxidational wear of steel10.1016/S0043-1648(02)00230-2 ↗
53. Oxidation of WC-Co, WC-Ni and WC-Co-Ni hard metals in the temperature range 500-800ºC10.1016/0263-4368(96)00009-1 ↗
54. Wear behaviour of WC-Co HVOF coatings at different temperatures in air and argon10.1016/j.wear.2015.01.035 ↗
55. Structures of the ReO3-type with recurrent dislocations of atoms 'homologous series' of molybdenum and tungsten oxides10.1107/S0365110X53001381 ↗
56. The role of Oxide Tribofilms on Friction and Wear of Different Thermally Sprayed WC-CoCr10.1007/s11666-017-0522-0 ↗
57. Mechanism of the early stages of oxidation of WC-Co cemented carbides10.1016/j.corsci.2015.11.007 ↗
58. Cobalt oxide surface chemistry The interaction of CoO(1 0 0), Co3O4(1 1 0), and Co3O4(1 1 1) with oxygen and water10.1016/j.molcata.2007.08.023 ↗
59. The Effect of Oxide Volatization on the Oxidation Kinetics of Cr and Fe-Cr Alloys10.1149/1.2424115 ↗
60. High temperature oxidation of HVOF thermally sprayed NiCr-Cr3C2 coatings microstructure and kinetics10.1007/s10853-015-9238-z ↗
61. High temperature oxidation studies of detonation-gun-sprayed Cr3C2-NiCr coating on Fe- and Ni-based superalloys in air under cyclic conditions at 900ºC10.1016/j.jallcom.2008.04.087 ↗
62. Chattopadhyay R · 2001
63. Nickel chromium plasma sprayed coatings A way to enhance degradation resistance of boiler tube steels in boiler environment10.1361/105996306X92695 ↗
64. Friction and wear of chromium carbide-nickel alloys at temperatures of 20-1000ºC10.1007/BF00792456 ↗
65. Oxidation Mechanisms of Ni-20Cr Foils and Its Relation to the Oxide Scale Microstructure10.1023/A:1004578513020 ↗
66. Effect of material hardness on erosive wear behaviour of some weld deposited alloys10.1081/AMP-120003529 ↗
67. Study of the tribological behaviors and wear mechanisms of WC-Co and WC-Fe3Al hard materials under dry sliding condition10.1016/j.triboint.2016.12.023 ↗
68. Effect of sliding speed on the frictional behavior and wear performance of borided and plasma-nitrided W9Mo3Cr4V high-speed steel
69. Microstructural characterization and wear behaviour of High Velocity Oxy Fuel sprayed Cr3C2-25NiCr coating10.1016/j.matpr.2018.06.089 ↗