Fe/Cr ratio controls interfacial Laves phase formation in FeCrAl-coated Zircaloy-4 during steam oxidation
Bibliographic record
Abstract
No abstract is available for this record. The assistant can identify its topic from the title, but cannot infer the study’s results.
Source: Not provided · Quality: missing
Research context
OpenAlex topics: Nuclear Materials and Properties · High-Temperature Coating Behaviors · Nuclear reactor physics and engineering
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (69)
Show source-provided references
1. Oxidation, mutual diffusion and crack behaviors of high-throughput prepared CrAl coating on Zry-4 in steam at 1200 °C10.1016/j.corsci.2025.113028 ↗
2. Oxidation behavior of CrAl-Mo coated Zircaloy-4 in DB and BDB scenarios10.1016/j.corsci.2023.111157 ↗
3. Oxidation behavior of CrAl coating with and without Nb addition in high temperature steam environment10.1016/j.jnucmat.2023.154437 ↗
4. Grain boundary-mediated Zr diffusion and Cr2O3 reduction governing steam oxidation degradation in Cr-coated Zr alloy10.1016/j.corsci.2026.113788 ↗
5. Evolution of fatigue-induced cracks in Cr-coated Zr alloy cladding in high-temperature steam environment10.1016/j.corsci.2026.113722 ↗
6. Insights into the complexities of diffusion-induced grain boundary migration in Fe-Cr-Ni ternary alloys10.1016/j.actamat.2025.121836 ↗
7. Systematic investigation of the oxidation behavior of Fe-Cr-Al cladding alloys in high-temperature steam10.1016/j.corsci.2022.110595 ↗
8. An Overview of Mechanisms of the degradation of promising ATF cladding materials during oxidation at high temperatures
9. Anomalous oxidation behavior and enhanced corrosion resistance of a lean-Cr FeCrAl alloy in the oxygenated PWR primary water10.1016/j.corsci.2025.113452 ↗
10. Corrosion behavior of Nb-doped FeCrAl alloy in 500°C steam10.1016/j.corsci.2024.112036 ↗
11. Stiffness mismatch-induced interfacial delamination governs fretting-corrosion degradation of Cr–Mo coated Zr alloy in simulated PWR water10.1016/j.corsci.2026.114067 ↗
12. Suppression of dynamic recovery via localized solute pinning for superior high-temperature strength in a lightweight refractory medium-entropy alloy10.1016/j.actamat.2026.122459 ↗
13. Microstructure evolution and oxidation behavior of bi-layer CrAl-Mo coated Zircaloy-4 in steam at 1200 °C and 1300 °C
14. High-temperature steam oxidation behavior and failure mechanisms of Al alloyed Cr coatings on Zr-4 alloy10.1016/j.corsci.2024.111898 ↗
15. Thermo-mechanical analysis of LWR SiC/SiC composite cladding10.1016/j.jnucmat.2014.01.006 ↗
16. Steam oxidation of silicon carbide at high temperatures for the application as accident tolerant fuel cladding, an overview10.3390/thermo1020011 ↗
17. Uniform corrosion of FeCrAl alloys in LWR coolant environments10.1016/j.jnucmat.2016.06.047 ↗
18. A study of the oxidation of FeCrAl alloy in pressurized water and high-temperature steam environment10.1016/j.corsci.2015.02.027 ↗
19. Characteristic, corrosion and high-temperature steam oxidation behavior of FeCrAl-coated Zr alloy by magnetron sputtering: Synergistic effect of deposition temperature and substrate bias10.1016/j.surfcoat.2025.131783 ↗
20. Growth kinetics and microstructure characteristics of the Zr-Cr interlayer in a Cr-coated Zry-4 alloy exposed to high-temperature steam10.1016/j.corsci.2023.111600 ↗
21. Autoclave grid-to-rod fretting corrosion behaviors of the Zr alloy fuel cladding with and without Cr coating through advanced characterization10.1016/j.corsci.2024.112379 ↗
22. Hetero-lamellar design alleviates the Ubiquitous strength-ductility trade-off in high-entropy alloys10.1016/j.intermet.2026.109316 ↗
23. Investigations of oxidation behavior and establishment of life-cycle model during the steam oxidation of Cr-coated Zry-4 at 1200 °C10.1016/j.corsci.2023.111694 ↗
24. A systematic study of the oxidation behavior of Cr coatings on Zry4 substrates in high temperature steam environment10.1016/j.corsci.2020.108826 ↗
25. Superior corrosion resistance and crack tolerance of FeCrAl coatings on Zr alloy under hydrogenated and oxygenated PWR primary water10.1016/j.corsci.2025.113492 ↗
26. Grain boundary-controlled dissolution of Cr coatings on Zr alloy cladding in oxygenated high-temperature water10.1016/j.corsci.2025.113571 ↗
27. The oxidation-dissolution behavior of Cr-coated Zr alloy in high temperature water10.1016/j.jnucmat.2024.155504 ↗
28. Synergistic strengthening via reduced phase property mismatch in a dual-phase high-entropy alloy enabled by bidirectional precipitation engineering10.1016/j.jallcom.2026.188785 ↗
29. Sequential δ/γ interfacial degradation induces a sigmoidal kinetic transition in stress corrosion cracking during superlong-term thermal aging of duplex stainless steel10.1016/j.actamat.2026.122314 ↗
30. High temperature oxidation of Fe-Al and Fe-Cr-Al alloys: The role of Cr as a chemically active element10.1016/j.corsci.2010.06.019 ↗
31. Oxidation behavior of FeCrAl coated Zry-4 under high temperature steam environment10.1016/j.corsci.2019.01.004 ↗
32. Interface reactions and mechanical properties of FeCrAl-coated Zircaloy-410.1016/j.jnucmat.2019.03.004 ↗
33. Effect of molybdenum addition on oxidation behavior and secondary protection mechanism of FeCrAl coatings10.1016/j.matchar.2023.113221 ↗
34. Mitigating grain boundary gd segregation to enhance high-temperature oxidation resistance in Mg-6Gd-1Al alloy: A comparative microstructural study10.1016/j.corsci.2025.113256 ↗
35. Microstructure-dependent volatilization of haynes 230 alloy in ultrahigh vacuum at high temperatures10.1016/j.corsci.2026.113821 ↗
36. Microstructural evolution of the Cr/FeCrAl coated Zircaloy-4 under simulated PWR and high-temperature steam oxidation environments10.1016/j.jnucmat.2024.155266 ↗
37. Improved oxidation resistance of Cr/FeCrAl coating on Zr alloy in high-temperature steam environment10.1016/j.surfcoat.2023.129992 ↗
38. Bidirectional degradation of the Mo diffusion barrier in FeCrAl-coated Zircaloy-4 during steam oxidation above the Fe-Zr eutectic temperature10.1016/j.corsci.2026.114074 ↗
39. Oxide Morphology of a FeCrAl Alloy, Kanthal APMT, Following Extended Aging in Air at 300 °C to 600 °C10.1007/s11661-018-4649-5 ↗
40. Microstructure, oxidation and corrosion properties of FeCrAl coatings with low Al content prepared by magnetron sputtering for accident tolerant fuel cladding10.1016/j.jnucmat.2021.152966 ↗
41. Thermodynamic modeling and experimental study of the Fe-Cr-Zr system10.1016/j.jnucmat.2013.05.061 ↗
42. Experimental determination of intermetallic phases, phase equilibria, and invariant reaction temperatures in the Fe-Zr system10.1361/105497102770331172 ↗
43. The Fe−Zr (Iron-Zirconium) system10.1007/BF02881963 ↗
44. The Cr−Zr (Chromium-Zirconium) system10.1007/BF02868997 ↗
45. X.C.Y. Wang, X. Wang, C. Tang, Z. Shen, X. Zeng, Progress in failure mechanisms and modification strategies of nickel-based alloys for molten salt reactors, Acta Metall. Sin.
46. Mitigating ZrCr2 formation at the Cr/Zr interface through trace doping of Zn, Mg and Sn into Cr coatings: A combined first-principles computational and experimental investigation10.1016/j.jnucmat.2024.155375 ↗
47. Experimental kinetic study of interdiffusion behavior and intermetallic compound Zr(Fe,Cr)2 formation at the Cr/Zry4 interface under elevated temperatures10.1016/j.jnucmat.2023.154595 ↗
48. Microstructure-dependent high-temperature oxidation behavior of Mn-Containing β-solidifying γ-TiAl alloys10.1016/j.corsci.2025.113579 ↗
49. Study on Nb interlayer as Cr-Zr diffusion barrier layer at high-temperature10.1016/j.ijrmhm.2024.106956 ↗
50. Diffusion of chromium of Cr-coated Zircaloy accident tolerant fuel cladding: Model development and experimental validation10.1016/j.surfcoat.2023.129698 ↗
51. Revisiting the thermodynamic properties of the ZrCr2 Laves phases by combined approach using experimental and simulation methods10.1016/j.jallcom.2024.175186 ↗
52. Phase Selection and Microstructure Evolution Dependance on Composition for Zr-Fe Eutectic Alloys10.1007/s40195-024-01736-7 ↗
53. Multiphase diffusion in binary and ternary solid-state systems10.1016/0079-6786(90)90007-3 ↗
54. First-principles calculation of self-diffusion coefficients10.1103/PhysRevLett.100.215901 ↗
55. fundamentals, methods, materials, diffusion-controlled processes
56. Kinetic theory of flux-driven ripening10.1103/PhysRevB.66.115403 ↗
57. Kinetics of formation of silicides: A review10.1557/JMR.1986.0205 ↗
58. Observations of nodule growth during the oxidation of pure binary iron-aluminum alloys10.1007/BF00666643 ↗
59. The nature of the third-element effect in the oxidation of Fe-xCr-3 at% Al alloys in 1 atm O2 at 1000 °C10.1016/j.corsci.2007.06.019 ↗
60. Transport processes during the growth of oxide films at elevated temperature10.1103/RevModPhys.57.437 ↗
61. Metastable alumina polymorphs: Crystal structures and transition sequences10.1111/j.1151-2916.1998.tb02581.x ↗
62. Effect of the θ-α-Al2O3 transformation on the oxidation behavior of β-NiAl+Zr10.1007/BF00846690 ↗
63. The oxidation behaviour of NiAl-I. Phase transformations in the alumina scale during oxidation of NiAl and NiAl-Cr alloys10.1016/0010-938X(92)90002-K ↗
64. High-temperature steam corrosion performance of FeCrAl alloys after long-term service in PWR condition: A reliable evaluation and multiscale microstructural characterization10.1016/j.corsci.2026.113747 ↗
65. Diffusion of cations in chromia layers grown on iron-base alloys10.1007/BF00665632 ↗
66. Molecular dynamics simulations of vacancy diffusion in chromium(III) oxide, hematite, magnetite and chromite10.1016/j.ssi.2014.11.027 ↗
67. Effect of Al content and a Cr-N diffusion barrier on the high-temperature steam oxidation of FeCrAl coatings on Zry-410.1016/j.jnucmat.2025.156422 ↗
68. Effect of Si addition on the oxidation of a 12Cr1Al ODS alloy in liquid LBE10.1016/j.pnucene.2025.106226 ↗
69. Mesoscopic connectivity of second phases regulates long-term oxidation stability in Mg–RE alloys: A topological isolation strategy10.1016/j.actamat.2026.122519 ↗