Figure of merit for the quality of ZrO2 coatings on stainless steel and nickel-based alloy surfaces

Abstract A figure of merit (FOM) has been developed to define the quality of ceramic (e.g., ZrO 2 ) coatings on metal and alloy [Type 304SS and Alloy 600] surfaces. Zirconia (ZrO 2 ) coatings were developed as a means of protecting the metal/alloy surfaces from stress corrosion cracking (SCC) in boiling water reactor (BWR) primary heat transport circuits, by inhibiting the cathodic reaction (reduction of oxygen and hydrogen peroxide) on the surface external to the crack. The distribution of pores in the coating plays an important role in corrosion prevention, such that the lower the porosity of the coating, the better the protection afforded to the system against SCC. Since the reactors operate at high temperature (e.g., at 288 °C under full power conditions), the temperature dependence of the FOM was investigated. The figure of merit (FOM) was developed by measuring impedance data over a wide range of frequency (10 mHz–5 kHz) at temperatures of 25, 100, 200, and 288 °C in hydrogenated, buffered solutions, with the hydrogen electrode reaction (HER) being used as a “fast” redox couple. An “equivalent circuit” analog was first developed from the bare surface impedance data and this analog was then employed in a second step to model the pore bottom in defining the pore distribution on the coated surface. A lognormal distribution (LND) of the pores was assumed and the parameters of the LND were determined using a constrained optimization technique to fit the model to the experimental data for the coated surface at different temperatures. The results suggest that, as temperature increases, the coating becomes more porous, making the substrate more susceptible to corrosion cracking. At 288 °C, 87% of the SS and 85% of the Ni-alloy surfaces become porous with the pore radius varying from 0.0001 cm to 0.01 cm.