Tribocorrosion behaviour of aluminium bronze in 3.5 wt.% NaCl solution
Source abstract
Abstract
Tribocorrosion behaviour of aluminium bronze CuAl10Fe5Ni5 in 3.5 wt.% NaCl solution was investigated in a pin-on-disc facility containing an electrochemical cell. Oxidising capacity and contact pressure to alumina counterbody were varied. Pure corrosion occurred as selective dissolution of α phase included in the eutectoid structure. Contact to counterbody introduced plastic deformation, extrusion of the material and abrasive wear. Wear-corrosion interactions varied between the two contact pressures, with lower material losses appearing at the higher pressure. The significant acceleration of material degradation by the interactions was not clearly reflected to kinetics or thermodynamics of corrosion. These results are presented and discussed here.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Metallurgy and Material Science · Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (49)
Show source-provided references
1. Richardson · 2016
2. Load-dependent tribocorrosion behavior of nickel-aluminium bronze in artificial seawater10.1016/j.corsci.2017.11.028 ↗
3. Erosion-corrosion interactions and their effect on marine and offshore materials10.1016/j.wear.2006.03.033 ↗
4. Electrochemical methods in tribocorrosion: a critical appraisal10.1016/S0013-4686(01)00679-X ↗
5. Effect of surface chemistry on the mechanical response of metals in sliding tribocorrosion systems10.1016/j.wear.2007.01.066 ↗
6. The effect of mechanical and electrochemical parameters on the tribocorrosion rate of stainless steel in sulphuric acid10.1016/S0043-1648(03)00085-1 ↗
7. Analysis of the tribocorrosion mechanisms in a pin-on-plate combination on the example of AISI304 steel10.1016/j.wear.2012.07.013 ↗
8. Tribocorrosion of stainless steel in sulphuric acid: identification of corrosion-wear components and effect of contact area10.1016/j.wear.2010.03.010 ↗
9. Mechanical and chemical mechanisms in the tribocorrosion of a Stellite type alloy10.1016/j.wear.2013.04.007 ↗
10. The effect of contact configuration on the tribocorrosion of stainless steel in reciprocating sliding under potentiostatic control10.1016/S0010-938X(02)00136-1 ↗
11. Tribocorrosion behaviour of Fe-17Cr stainless steel in acid and alkaline solutions10.1016/S0301-679X(99)00051-1 ↗
12. Triboelectrochemical techniques and interpretation methods in tribocorrosion: a comparative evaluation10.1016/j.triboint.2007.11.003 ↗
13. Effect of applied potential on the tribocorrosion behaviours of Monel K500 alloy in artificial seawater10.1016/j.triboint.2014.07.014 ↗
14. Tribocorrosion behaviour of AISI 304 stainless steel in 0.5 M NaCl solution10.1016/j.matchemphys.2011.03.063 ↗
15. Behaviour of leaded tin bronze in simulated seawater in the absence and presence of tribological contact with alumina counterbody: corrosion, wear and tribocorrosion10.1016/j.triboint.2018.08.021 ↗
16. Tribocorrosion study of martensitic and austenitic stainless steels in 0.01 M NaCl solution10.1016/j.triboint.2015.11.046 ↗
17. The role of surface chemistry and fatigue on tribocorrosion of austenitic stainless steel10.1016/j.triboint.2016.07.020 ↗
18. Influence of microstructure evolution on tribocorrosion of 304SS in artificial seawater10.1016/j.corsci.2014.07.062 ↗
19. Tribocorrosion behaviour of new martensitic stainless steels in sodium chloride solution10.1016/j.wear.2016.09.002 ↗
20. Tribocorrosion of UNS S32750 in chloride medium: effect of the load level10.1016/j.electacta.2011.07.077 ↗
21. Surface engineering of Ti6Al4V surfaces for enhanced tribocorrosion performance in artificial seawater10.1016/j.matdes.2016.04.080 ↗
22. Erosion-corrosion resistance of engineering materials in various test conditions10.1016/j.wear.2009.01.052 ↗
23. Effect of heat treatment on microstructure evolution and erosion-corrosion behaviour of a nickel-aluminium bronze alloy in chloride solution10.1016/j.corsci.2015.05.037 ↗
24. Synergistic effects of cavitation erosion and corrosion for nickel aluminium bronze with oxide film in 3.5% NaCl solution10.1016/j.wear.2017.01.047 ↗
25. J. Basumatary, R.J.K. Wood, Different methods of measuring synergy between cavitation erosion and corrosion for nickel aluminium bronze in 3.5% NaCl solution. Tribology International, in press. DOI: https://doi.org/10.1016/j.triboint.2017.08.006.10.1016/j.triboint.2017.08.006 ↗
26. Marine wear and tribocorrosion10.1016/j.wear.2017.01.076 ↗
27. A method to predict pitting corrosion of stainless steel in evaporative conditions10.1016/j.jcsr.2008.07.001 ↗
28. Tribocorrosion behavior of mooring high strength low alloy steels in synthetic seawater10.1016/j.wear.2015.05.004 ↗
29. Influence of heat treatment on the microstructure and mechanical properties of aluminium bronze
30. The corrosion of nickel-aluminium bronze in seawater10.1016/j.corsci.2005.05.053 ↗
31. Stachowiak · 2014
32. The corrosion of nickel-aluminium bronzes in seawater –I. Protective layer formation and the passivation mechanism10.1016/0010-938X(93)90017-B ↗
33. The influence of nickel-aluminium bronze microstructure and crevice solutions on the initiation of crevice corrosion10.1016/j.electacta.2007.10.047 ↗
34. The characterization of Sn-based corrosion products in ancient bronzes: a Raman approach10.1002/jrs.4037 ↗
35. Friction and wear of nanostructured metals created by large strain extrusion machining10.1016/j.wear.2006.11.040 ↗
36. Conduction degradation by fretting corrosion phenomena for contact samples made of high-copper alloys10.1016/j.triboint.2010.06.006 ↗
37. The role of oxidation in the friction and wear behavior of solid solution Cu-Al alloys in reciprocating sliding contact with sapphire and D2 tool steel10.1016/0043-1648(92)90225-W ↗
38. Tribocorrosion behaviour of Ti6Al4V in artificial seawater at low contact pressures10.1016/j.triboint.2017.10.025 ↗
39. Sliding tribocorrosion behavior of bulk metallic glass against bearing steel in 3.5% NaCl solution10.1016/j.triboint.2015.02.021 ↗
40. Tribo-corrosion behaviour of chromium carbide coatings deposited by HVOF10.1016/j.surfcoat.2014.10.007 ↗
41. Modelling the tribo-corrosion interactions in aqueous sliding conditions10.1016/S0301-679X(02)00058-0 ↗
42. 2016
43. The tribo-corrosion behaviour of Cu-9wt.% Ni-6 wt.% Sn alloy10.1016/j.triboint.2015.06.031 ↗
44. Effect of 4-point bending and normal load on the tribocorrosion-fatigue (multi-degradation) of stainless steels10.1016/j.triboint.2016.03.016 ↗
45. Multi-degradation behavior of austenitic and super duplex stainless steel -The effect of 4-point static and cyclic bending applied to a simulated seawater tribocorrosion system10.1016/j.wear.2012.02.016 ↗
46. Jones · 1992
47. The role of nickel in mechanical performance and corrosion behavior of nickel-aluminium bronze in 3.5wt.% NaCl solution10.1016/j.corsci.2018.05.012 ↗
48. Microstructure design to improve the corrosion and cavitation corrosion resistance of a nickel-aluminium bronze10.1016/j.corsci.2018.04.043 ↗
49. The synergistic effect of cavitation erosion and corrosion of nickel-aluminium copper surface layer on nickel-aluminium bronze alloy10.1016/j.jallcom.2018.03.103 ↗