journal article·2017-11-02

An evaluation of high temperature hydrogen attack resistance and a possible new microstructure development based remnant life assessment method of a clean ASME Gr.91 thick section steel plate

Y. Hasegawa, H. Kumagai, F. Kawazoe, M. Okushima, H. Furuya, M. Kodama, T. Nagao

Materials at High Temperatures· Volume 34· Issue 5-6
Publisher page

Abstract

A thick section plate specimen of a completely refined Gr.91 steel plate met the requirements of ASME code concerning the toughness and creep strengths due to exact control of the chemical composition and lowering of impurities. Low impurities also resulted in almost the same HTHA (High Temperature Hydrogen Attack) resistance as that of 2.25Cr-1Mo steel at 500ºC at 20 MPa hydrogen pressure. The long-term creep strength of Gr.91 steel is reduced by the presence of weld heat-affected-zones. The weakening phenomenon is due to the formation of ‘Type IV damage’. In this study, a crystal misorientation diagram transition analysis method using electron-back-scattering-diffraction analysis, EBSD, is applied to predict the remnant creep life of the HAZ. The trial prediction agrees with the actual rupture time.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Hydrogen embrittlement and corrosion behaviors in metals · Microstructure and Mechanical Properties of Steels · Material Properties and Failure Mechanisms

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Futtsu Unit, Material Properties Evaluation Division, Nippon Steel & Sumikin Technology, 20-1, Shintomi, Suttsu, 293-0011, Chiba, Japan

Nagoya Steel Works, Plate Products Quality Management Department, Quality Management Division, Nippon Steel & Sumitomo Metal Corporation, 5-3, Tokaimachi, Tokai City, Aichi Pref. 476-8686, Japan

Nagoya R&D Laboratory, Nippon Steel & Sumitomo Metal Corporation, 5-3, Tokaimachi, Tokai City, Aichi Pref. 476-8686, Japan

Plate Products Technical Service & Solution Department, Plate Technology Division, Nippon Steel & Sumitomo Metal Corporation, Head Office, 6-1, Marunouchi 2-chome, Chiyoda-ku, Tokyo 100-8071, Japan

References (1)

Show source-provided references
1. 10.1007/BF0264193410.1007/BF02641934 ↗