journal article·2016-10

Thermally activated energy dissipation in semi-crystalline polymer nanocomposites

Frank Gardea, Bryan Glaz, Jaret Riddick, Dimitris C. Lagoudas, Mohammad Naraghi

Publisher page

Abstract

Abstract In this manuscript, we demonstrate the concept of active damping in semi-crystalline thermoplastics which are reinforced with a percolated network of CNTs, where the damping of the composite was augmented considerably, controllably and reversibly via Joule heating. The Joule heating triggered relaxation mechanisms in the amorphous phase of the matrix. To this end, semi-crystalline poly ether ether ketone (PEEK) polymer and PEEK/carbon nanotube (CNT) composites were fabricated and their viscoelastic properties were studied. The damping performance was experimentally tested by dynamic mechanical analysis. The polymer relaxation resulting from an increase in temperature, triggered by the Joule heating of the nanoparticles, demonstrated the potential for damping enhancement in the composite. A considerable enhancement in damping (by as much as 400%) was achieved at a significantly lower relative loss in storage modulus (40%), both caused by relaxation mechanisms in Joule heated samples. This enhancement in damping corresponds to a 150% improvement in the figure of merit for damping materials. The non-uniform temperature distribution in the sample was measured experimentally at the macroscale and estimated via continuum models at the microscale. It was concluded that non-uniform temperature distribution in the composite, especially at the microscale, had a large effect on the overall damping enhancement. Based on the microscale models, potential mechanisms by which the active damping can be enhanced were discussed.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Carbon Nanotubes in Composites · Tribology and Wear Analysis · Polymer Nanocomposites and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. Theory and application of dynamic mechanical thermal analysis10.1016/0040-6031(91)80240-J ↗
2. Interfacial strain energy dissipation in hybrid nanocomposite beams under axial strain fields10.2514/1.J053390 ↗
3. Future directions in rotorcraft technology at ames research center
4. Energy absorption capability of nanocomposites: a review10.1016/j.compscitech.2009.06.020 ↗
5. On the impact response of electrified carbon fiber polymer matrix composites: effects of electric current intensity and duration10.1016/j.compscitech.2007.09.019 ↗
6. Thermal and mechanical response of a carbon fiber reinforced composite to a transverse impact and in-plane pulsed electromagnetic loads10.1115/1.4006507 ↗
7. Simultaneous stiffness-damping optimization of structures with respect to acceleration, displacement and base shear10.1016/j.engstruct.2007.01.001 ↗
8. Recent research on enhancement of damping in polymer composites10.1016/S0263-8223(98)00073-7 ↗
9. Energy dissipation due to interfacial slip in nanocomposites reinforced with aligned carbon nanotubes10.1021/acsami.5b01459 ↗
10. Polymer nanocomposites: a small part of the story10.1007/s11837-007-0040-5 ↗
11. Effect of thermal interface on heat flow in carbon nanofiber composites10.1021/am4046102 ↗
12. Characterization of electrical and thermal properties of carbon nanotube/epoxy composites10.1016/j.compositesb.2013.08.032 ↗
13. Smart tuned mass dampers
14. Victrex® poly(ethersulfone) (PES) and Victrex® poly(etheretherketone) (PEEK)10.1002/pen.760250808 ↗
15. Development and characterization of PEEK/carbon nanotube composites10.1016/j.carbon.2009.07.020 ↗
16. Novel nanocomposites reinforced with hydroxylated poly (ether ether ketone)-grafted carbon nanotubes10.1039/c0jm01531h ↗
17. Denault, J. and M. Dumouchel, Consolidation process of PEEK/carbon composite for aerospace applications. Adv. Perform. Mater.. 5(1): p. 83–96.10.1023/A:1008638105370 ↗
18. PEEK biomaterials in trauma, orthopedic, and spinal implants10.1016/j.biomaterials.2007.07.013 ↗
19. High damping composite materials: effect of structural hierarchy10.1177/0021998302036003538 ↗
20. Vibration suppression by variable-stiffness members10.2514/3.59943 ↗
21. The mechanical properties of poly (ether-ether-ketone)(PEEK) with emphasis on the large compressive strain response10.1016/j.polymer.2006.11.032 ↗
22. The measurement of the crystallinity of polymers by DSC10.1016/S0032-3861(02)00235-5 ↗
23. On crystallization phenomena in PEEK10.1016/0032-3861(88)90386-2 ↗
24. Analysis of high-loss viscoelastic composites10.1007/BF01154935 ↗
25. Complex moduli of viscoelastic composites—I. General theory and application to particulate composites10.1016/0020-7683(70)90029-6 ↗
26. Morphological changes during secondary crystallization and subsequent melting in poly (ether ether ketone) as studied by real time small angle X-ray scattering10.1021/ma951727o ↗
27. On the origin of the multiple endotherms in PEEK10.1016/0032-3861(92)90391-9 ↗
28. Morphology and crystallization behavior of HDPE/CNT nanocomposite10.1080/00222340500522299 ↗
29. Carbon-nanofibre-reinforced poly (ether ether ketone) composites10.1016/S1359-835X(02)00084-2 ↗
30. Shape and temperature memory of nanocomposites with broadened glass transition10.1126/science.1145593 ↗
31. High-performance nanocomposites based on polyetherketones10.1016/j.pmatsci.2012.03.003 ↗
32. Dynamic mechanical and morphological properties of polycarbonate/multi-walled carbon nanotube composites10.1016/j.polymer.2005.04.075 ↗
33. Dynamic mechanical study of the factors affecting the two glass transition behavior of filled polymers. Similarities and differences with random ionomers10.1021/ma00122a011 ↗
34. Amorphous-to-crystalline transition of Polyetheretherketone-carbon nanotube composites via resistive heating10.1016/j.compscitech.2013.09.012 ↗