Synthesis and high-temperature creep behavior of a SiLuOC-based glass-ceramic
Source abstract
Abstract
In this work, a lutetium-modified silicon oxycarbide (SiOC) glass ceramic was prepared from a single-source precursor via pyrolysis and subsequent hot pressing. It is shown that the main crystalline phase in the hot-pressed SiLuOC is Lu2Si2O7. The high-temperature (HT) creep behavior of SiLuOC was assessed by compression creep experiments performed between 1100 and 1300°C at constant true stresses between 25 and 75 MPa. The calculated viscosity values of SiLuOC were found to be significantly higher as compared to those of SiRE(Al,Mg)ON glasses (RE = rare earth elements). Thus, the presented SiLuOC-based glasses might be used as alternative sintering aids for the liquid-phase sintering of HT creep resistant Si3N4 monolithic samples.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced ceramic materials synthesis · Advanced materials and composites · Recycling and utilization of industrial and municipal waste in materials production
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Technische Universität Darmstadt, Institut für Materialwissenschaft
Karlsruher Institut für Technologie, Institut for Applied Materials
Technische Universität Darmstadt, Institut für Angewandte Geowissenschaften
References (30)
Show source-provided references
1. 1) G. Ziegler, J. Heinrich and G. Woetting, J. Mater. Sci., 22, 3041–3086 (1987).10.1007/BF01161167 ↗
2. 2) T. Rouxel, G.-D. Soraru and J. Vicens, J. Am. Ceram. Soc., 84, 1052–1058 (2001).10.1111/j.1151-2916.2001.tb00789.x ↗
3. 3) C. Moysan, R. Riedel, R. Harshe, T. Rouxel and F. Augereau, J. Eur. Ceram. Soc., 27, 397–403 (2006).10.1016/j.jeurceramsoc.2006.01.016 ↗
4. 4) G. D. Soraru, E. Dallapiccola and G. D’Andrea, J. Am. Ceram. Soc., 79, 2074–2080 (1996).10.1111/j.1151-2916.1996.tb08939.x ↗
5. 5) M. Esfehanian, R. Oberacker, T. Fett and M. J. Hoffmann, J. Am. Ceram. Soc., 91, 3803–3805 (2008).10.1111/j.1551-2916.2008.02730.x ↗
6. 6) A. Saha, R. Raj and D. L. Williamson, J. Am. Ceram. Soc., 89, 2188–2195 (2006).10.1111/j.1551-2916.2006.00920.x ↗
7. 7) S. J. Widgeon, S. Sen, G. Mera, E. Ionescu, R. Riedel and A. Navrotsky, Chem. Mater., 22, 6221–6228 (2010).10.1021/cm1021432 ↗
8. 8) A. Saha and R. Raj, J. Am. Ceram. Soc., 90, 578–583 (2007).10.1111/j.1551-2916.2006.01423.x ↗
9. 9) L. Bois, J. Maquet, F. Babonneau and D. Bahloul, Chem. Mater., 7, 975–981 (1995).10.1021/cm00053a025 ↗
10. 10) T. Plachky, Z. Lences, L. Hric, P. Sajgalik, P. Balaz, R. Riedel and H. J. Kleebe, J. Eur. Ceram. Soc., 30, 759–767 (2010).10.1016/j.jeurceramsoc.2009.08.014 ↗
11. 11) P. F. Becher, N. Shibata, G. S. Painter, F. Averill, K. van Benthem, H.-T. Lin and S. B. Waters, J. Am. Ceram. Soc., 93, 570–580 (2010).10.1111/j.1551-2916.2009.03435.x ↗
12. 12) P. F. Becher and M. K. Ferber, J. Am. Ceram. Soc., 87, 1274–1279 (2004).10.1111/j.1151-2916.2004.tb07722.x ↗
13. 13) N. Saito, D. Nakata, K. Nakashima, and A. Umemoto, Grain growth of β-silicon nitride in RE-Mg-Si-O-N liquid, “Ceram. Trans.”, 192(Developments and Applications of Advanced Engineering Ceramics and Composites) (2006) pp. 73–80.
14. 14) M. J. Hoffmann, H. Gu and R. M. Cannon, Influence of the interfacial properties on the microstructural development and properties of silicon nitride ceramics, “Mater. Res. Soc. Symp. Proc.”, 586(Interfacial Engineering for Optimized Properties II) (2000) pp. 65–74.
15. 15) D. Schliephake, M. Azim, K. von Klinski-Wetzel, B. Gorr, H.-J. Christ, H. Bei, E. P. George and M. Heilmaier, Metall. Mater. Trans., A Phys. Metall. Mater. Sci., 45, 1102–1111 (2014).10.1007/s11661-013-1944-z ↗
16. 16) J. R. Davis, “Tensile Testing”, 2 ed., ASM International (2004) p. 283.
17. 17) G. Socrates, “Infrared and Raman Characteristic Group Frequencies - Tables and Charts”, Third Edition ed., Chichester: John Wiley & Sons Ltd (2004).
18. 18) R. Al-Oweini and H. El-Rassy, J. Mol. Struct., 919, 140–145 (2009).10.1016/j.molstruc.2008.08.025 ↗
19. 19) S. M. Wiederhorn, R. F. Krause, Jr., F. Lofaj and U. Taeffner, Creep behavior of improved high temperature silicon nitride, “Key Eng. Mater.”, 287(Advanced Si-Based Ceramics and Composites) (2005) pp. 381–392.
20. 20) M. K. Cinibulk, G. Thomas and S. M. Johnson, J. Am. Ceram. Soc., 75, 2037–2043 (1992).10.1111/j.1151-2916.1992.tb04462.x ↗
21. 21) H. J. Kleebe, Phys. Status Solidi A, 166, 297–313 (1998).10.1002/(SICI)1521-396X(199803)166:1<297::AID-PSSA297>3.0.CO;2-3 ↗
22. 22) S. Martinez-Crespiera, E. Ionescu, H. J. Kleebe and R. Riedel, J. Eur. Ceram. Soc., 31, 913–919 (2011).10.1016/j.jeurceramsoc.2010.11.019 ↗
23. 23) G. M. Renlund, S. Prochazka and R. H. Doremus, J. Mater. Res., 6, 2723–2734 (1991).10.1557/JMR.1991.2723 ↗
24. 24) G. Hetherington, K. H. Jack and J. C. Kennedy, Phys. Chem. Glasses, 5, 130–136 (1964).
25. 25) J. H. Simmons, R. K. Mohr and C. J. Montrose, J. Appl. Phys., 53, 4075–4080 (1982).10.1063/1.331272 ↗
26. 26) C. Stabler, F. Roth, M. Narisawa, D. Schliephake, M. Heilmaier, S. Lauterbach, H.-J. Kleebe, R. Riedel and E. Ionescu, J. Eur. Ceram. Soc., 36, 3747–3753 (2016).10.1016/j.jeurceramsoc.2016.04.015 ↗
27. 27) A. Reger-Leonhard, M. Heilmaier and J. Eckert, Scr. Mater., 43, 459–464 (2000).10.1016/S1359-6462(00)00417-6 ↗
28. 28) B. S. S. Daniel, A. Reger-Leonhard, M. Heilmaier, J. Eckert and L. Schultz, Mech. Time-Depend. Mater., 6, 193–206 (2002).10.1023/A:1015045324786 ↗
29. 29) R. R. Harshe, “Synthesis and Processing of Amorphous Si(Al)OC Bulk Ceramics: High Temperature Properties and Applications”, in Department of Materials Science, Technical University of Darmstadt (2004) p. 222.
30. 30) P. F. Becher, S. Hampshire, M. J. Pomeroy, M. J. Hoffmann, M. J. Lance and R. L. Satet, Int. J. Appl. Glass Sci., 2, 63–83 (2011).10.1111/j.2041-1294.2011.00042.x ↗