Mechanical properties and corrosion behavior of electron beam cold hearth melting high strength and high corrosion resistant Ti-0.3Mo-0.8Ni alloy with different states

In this study, a large size Ti-0.3Mo-0.8Ni (TA10) alloy ingot melted by electron beam cold hearth melting (EBCHM) technology was investigated. The microstructure, mechanical properties, and corrosion behavior of as-cast, hot-rolled, and annealed TA10 alloys were investigated. The results show that different states of TA10 alloys have different microstructure and properties. The microstructure of as-cast TA10 alloy exhibits Widmanstätten α phase, hot-rolled TA10 sheet shows fibrous structure, with obvious rolling streamline. After 650 °C annealing, the intergranular β phase decreases, and most of the strip α phase changes to the equiaxed α phase. With the annealing temperature increases to 840 °C, the microstructure gradually changed from equiaxed structure to duplex structure. The mechanical properties of the TA10 alloy were enhanced after hot-rolling with an increase in ultimate tensile strength from 386.5 MPa to 610 MPa. Additionally, the elongation increased from 15.6 % to 23.3 %. Upon annealing at varying temperatures, it was observed that the strength decreased, reaching to 423.5 MPa at 650 °C and 478.2 MPa at 840 °C, while the plasticity increased significantly, reaching to 26.5 % at 650 °C and 28.6 % at 840 °C. The improved strength was attributed to the better grain boundary slip of the equiaxed structure. Corrosion resistance of titanium alloys is closely connected with their microstructure. The results of the immersion corrosion test indicate that the samples in various states exhibit similar corrosion behavior. Additionally, the hot-rolled TA10 alloy shows the highest corrosion resistance, with a lower corrosion rate of 0.34459 mm/year The as-cast TA10 alloy shows the lowest corrosion resistance, with a lower corrosion rate of 1.37559 mm/year.