Tribocorrosion Behaviour of SUS430 Stainless Steel in Aqueous Solutions with Different pH
Source abstract
Abstract
To reveal the influence of passive film on the tribocorrosion behaviour of stainless steel, SUS430 was loaded at 2.0 N or 10.0 N in aqueous solutions with various pH from 1.0 to 10.0. The pure wear behaviour was investigated in the air for comparison. The polarization behaviour, the morphology of the worn or tribocorroded surface, and the depth profiles of the formed groove were measured to discuss the mechanism. The passive state was confirmed at pH = 7.0 and 10.0, but vanished at pH = 1.0 and 2.0. The pure wear in air depended on the applied loads, rather than the sliding time. On the other hand, the tribocorrosion in deionised water was much smaller than the pure wear in air. Under a load of 2.0 N, the tribocorrosion at pH = 1.0 was weaker than pH = 2.0. However, the situation reversed when increasing the load to 10.0 N. The tribocorrosion in neutral and alkaline solutions is considerably smaller than in acid solutions.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Hydrogen embrittlement and corrosion behaviors in metals · Corrosion Behavior and Inhibition · Erosion and Abrasive Machining
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Department of Mechanical Systems Engineering, Hiroshima Institute of Technology, Hiroshima 731-5193, Japan
Graduate School of Science and Technology, Hiroshima Institute of Technology, Hiroshima 731-5193, Japan
Taiyo Electric Ind. Co., Ltd., Yamate, Fukuyama 720-0092, Japan
References (47)
Show source-provided references
1. Erosion-corrosion resistance of engineering materials in various test conditions10.1016/j.wear.2009.01.052 ↗
2. The synergistic effect of wear-corrosion in stainless steels: A review10.1016/j.matpr.2021.05.010 ↗
3. Tribocorrosion behavior and degradation mechanism of 316L stainless steel in typical corrosive media10.1007/s40195-020-01182-1 ↗
4. Tribocorrosion investigation of 316L stainless steel: The synergistic effect between chloride ion and sulfate ion10.1088/2053-1591/ac1825 ↗
5. Tribocorrosion behavior and degradation mechanism of 316L stainless steel in alkaline solution: Effect of tribo-film10.1007/s40195-022-01374-x ↗
6. In situ determinations of the wear surfaces, volumes and kinetics of repassivation: Contribution in the understanding of the tribocorrosion behaviour of a ferritic stainless steel in various pH10.1016/j.triboint.2020.106374 ↗
7. Using atomic force microscopy to measure thickness of passive film on stainless steel immersed in aqueous solution10.1038/s41598-019-49747-0 ↗
8. Passive and transpassive films on Fe-Cr alloys in acid and neutral solutions10.1016/0025-5416(80)90027-0 ↗
9. An overview on the passivity of metals10.1016/0010-938X(90)90086-K ↗
10. Influence of pH on the passivation behavior of 254SMO stainless steel in 3.5% NaCl solution10.1016/j.corsci.2006.10.032 ↗
11. Suppression effect of ultrasound on pitting corrosion of SUS304 stainless steel in various NaCl solutions10.1007/s11431-018-9383-3 ↗
12. Passive film of 18-8 stainless steel structure and its function10.1016/0010-938X(73)90031-0 ↗
13. Development and use of corrosion-resistant steels and alloys10.1007/s11041-010-9272-z ↗
14. Modeling tribocorrosion of passive metals—A review10.1016/j.cossms.2018.06.001 ↗
15. Tribocorrosion behaviour of Fe-17Cr stainless steel in acid and alkaline solutions10.1016/S0301-679X(99)00051-1 ↗
16. The effect of mechanical and electrochemical parameters on the tribocorrosion rate of stainless steel in sulphuric acid10.1016/S0043-1648(03)00085-1 ↗
17. Influence of ionic strength on hydrogen generation during interaction of copper with deoxy-genated neutral solution10.1016/j.corsci.2021.109552 ↗
18. Fontana, M.G., and Staehle, R.W. (1976). Advances in Corrosion Science and Technology: Volume 6 (Advances in Corrosion Science & Technology), Springer.10.1007/978-1-4684-8986-6 ↗
19. (2010). Testing Method for Wear Resistance of Fine Ceramics by Ball-on-Disc Method (Standard No. JIS R1613-2010).
20. Influence of dissolved oxygen on DL-EPR behavior of SUS329J4L duplex stainless steel after convection cooling10.2472/jsms.70.49 ↗
21. In situ analysis of passive films by potential modulated uv-visible reflection spectroscopy10.1016/0010-938X(90)90108-H ↗
22. The effect of chloride ion and dissolved oxygen concen-tration on passivation of SUS304 stainless steel
23. Optical characterization of passive oxides on metals10.5796/electrochemistry.84.826 ↗
24. Hashimoto, H. (2006). Kiso Kara Manabu, Morikita Publishing Co., Ltd.. (In Japanese).
25. Sasaki, S., Shima, M., Noguchi, S., Hirayama, T., Jibiki, T., Adachi, K., and Miyake, K. (2013). A 1st Course in Tribology, Kodansha. (In Japanese).
26. Munoz, A.I., Espallargas, N., and Mischler, S. (2020). Tribocorrosion, Springer Nature Switzerland AG.
27. Endou, K. (1976). Hyoumen Kougaku, Yokendo Ltd. Publishers. (In Japanese).
28. Effect of the applied potential of the near surface microstructure of a 316L steel submitted to tribocorrosion in sulfuric acid10.1088/0022-3727/39/15/S07 ↗
29. EBSD, SEM and FIB charac-terisation of subsurface deformation during tribocorrosion of stainless steel in sulphuric acid10.1016/j.wear.2010.04.023 ↗
30. Mechanical and chemical mechanisms in the tribocorrosion of a Stellite type alloy10.1016/j.wear.2013.04.007 ↗
31. Electrochemical Noise Analysis for Localized Corrosion of Type 304 Stainless Steel in Neutralized Chloride Solution10.3323/jcorr1991.50.323 ↗
32. Potential noise for stress corrosion cracking in corroding crevice-Report on the results of the cooperative experiment at the working group in Japan Society of Corrosion Engineering: “Detecting of the localized corrosions by the electro-chemical noise”10.3323/jcorr1991.49.99 ↗
33. Effect of impact angle on the slurry erosion–corrosion of 304L stainless steel10.1016/S0043-1648(00)00344-6 ↗
34. The synergistic effect between erosion and corrosion in acidic slurry medium10.1016/0043-1648(95)07132-6 ↗
35. Synergistic effect of corrosion and wear of the 316 stainless steel in molten zinc alloy at 460 °C10.1016/j.corsci.2019.108411 ↗
36. Tribocorrosion properties of AISI 1045 and AISI 2205 steels in seawater: Synergistic interactions of wear and corrosion10.1007/s40544-020-0376-1 ↗
37. The erosive wear of mild and stainless steels under controlled corrosion in alkaline slurries containing alumina particles10.1023/A:1004865107688 ↗
38. Bargmann, I., Neville, A., Hertzman, S., Reza, F., and Hu, X. (2009, January 22–26). Erosion-corrosion in oil and gas—Stainless steel under deaerated slurry impingement attack. Proceedings of the NACE—International Corrosion Conference Series, Atlanta, GA, USA.
39. Erosion-corrosion of stainless steels in aqueous slurries—a quantitative estimation of synergistic effects10.5006/1.3278157 ↗
40. Investigation of erosion-corrosion mechanisms of UNS S31603 using FIB and TEM10.1016/j.triboint.2011.05.012 ↗
41. Modelling the tribo-corrosion interaction in aqueous sliding conditions10.1016/S0301-679X(02)00058-0 ↗
42. Erosion–corrosion resistance of various stainless steel grades in high-temperature sulfuric acid solution10.1016/j.wear.2016.06.007 ↗
43. Interaction of mechanical and electrochemical factors in erosion-corrosion of carbon steel10.1016/j.electacta.2005.04.032 ↗
44. Modeling the multi-degradation mechanisms of combined tribocorrosion in-teracting with static and cyclic loaded surfaces of passive metals exposed to seawater10.1016/j.wear.2010.06.010 ↗
45. (2004). Standard Guide for Determining Synergism Between Wear and Corrosion (Standard No. G119 04).
46. Hydrogen entry into a high stength steel with tribocorrosion in acidic solution10.5346/trbane.2017.9 ↗
47. Electrochemical simulation of the current and potential response in sliding tribocorrosion10.1007/s11249-012-0022-9 ↗