Production of Al–Mn/WC Composite Coatings with Electrodeposition in AlCl3–NaCl–KCl–MnCl2 Molten Salts

The hardness and wear resistance of amorphous Al–Mn alloy coatings can be improved by incorporating ceramic particles into them to extend their application. In this paper, Al–Mn/WC composite coatings have been prepared with electrodeposition in stirred AlCl3–NaCl–KCl–MnCl2 molten salts at 180 °C with the addition of WC particles. The effects of stirring speed (400–700 rpm) and cathode current density (15–75 mA/cm2) on the produced Al–Mn/WC composite coatings have been studied. At 600 rpm and 700 rpm, the Al–Mn/WC composite coatings exhibited the best uniform distribution of the embedded WC particles, with the tested microhardness value up to 650 HV0.1, compared with 530 HV0.1 of the Al–Mn alloy. Moreover, under various cathode current densities, the best quality of the Al–Mn/WC composite coating was obtained at 55 mA/cm2, with a homogeneous distribution of WC particles and the highest microhardness value (670 HV0.1). It is expected that this method could be extended to be applied for the preparation of aluminum-based and magnesium-based ceramic composite coatings.