Improved Heat Dissipation of Dip-Coated Single-Walled Carbon Nanotube/Mesh Sheets with High Flexibility and Free-Standing Strength for Thermoelectric Generators

Single-walled carbon nanotubes (SWCNTs) are promising thermoelectric materials used in thermoelectric generators (TEGs) to power sensors. However, the limitation of SWCNTs is their high thermal conductivity, which makes it difficult to create a sufficient temperature difference. In this study, we fabricated dip-coated SWCNT/mesh sheets using an SWCNT dispersion. Several types of mesh materials were tested, and the most suitable material was polyphenylene sulfide (PPS). SWCNTs were uniformly deposited on the PPS mesh surface without filling the mesh openings. The SWCNT/PPS mesh sheets exhibited flexibility and free-standing strength. When the edge of the SWCNT/PPS mesh sheets were heated, a higher temperature gradient was produced compared with that of the conventional SWCNT film owing to the increase in heat dissipation. A flexible and free-standing TEG with an area of 1200 mm2, fabricated using SWCNT/PPS mesh sheets, exhibited an output voltage of 31.5 mV and maximum power of 631 nW at a temperature difference of 60 K (Tlow: 320 K). When the TEG was exposed to wind at 3 m/s, temperature difference further increased, and the performance of the TEG increased by a factor of 1.3 for output voltage and 1.6 for maximum power. Therefore, we demonstrated that the TEG’s performance could be improved using SWCNT/PPS mesh sheets.