Tailoring the Ductility of Ti-6Al-4V Titanium Alloy Fabricated by Laser Power Bed Fusion at Liquid Nitrogen Temperature

By tailoring different microstructural features, this study verifies that the laser powder bed fusion (LPBF)-fabricated Ti-6Al-4V titanium alloy with a fully α/β lamellar structure exhibits excellent ductility at liquid nitrogen temperature. HT-800 was obtained by holding at 800 °C for two hours and then furnace-cooled, resulting in a microstructure consisting of residual martensitic α’ phase, lamellar α phase, and particulate β phase. The HT-900 was obtained by holding at 900 °C for two hours and then furnace-cooled, completely eliminating the multi-level martensitic α’ phase generated during the LPBF process and resulting in an α/β lamellar structure. HT-900 achieved an elongation of 11% at liquid nitrogen temperature, a 47% improvement over the HT-800. After low-temperature strain fracture, the proportions of 61.38°<11–20> twin boundaries in the HT-800 and HT-900 were 21.4% and 26.4%, respectively, indicating that a substantial amount of deformation twinning is activated at liquid nitrogen temperature. Twinning induces the activation of slip systems by altering the orientation of surrounding grains. The coordinated plastic deformation of twinning and slip enhances the ductility of the HT-900 at 77 K. The results show that the LPBF-TC4 titanium alloy with a fully α/β lamellar structure exhibits superior, coordinated plastic deformation capabilities at 77 K, maintaining high strength while achieving greater ductility and fracture toughness.