The Effect of Laser-Cladded Co6, T400, and Ni-Based 30WC Coatings on the Wear Resistance of H13 Steel

To enhance the wear resistance of H13 steel (4Cr5MoSiV1), Co6, T400, and Ni-based 30WC coatings were applied to the surface of H13 steel using laser cladding technology. The microstructures and phase compositions of the three coating types were analyzed using SEM and XRD methods. The high-temperature friction and wear performance of the three coated samples and H13 steel were measured through high-temperature friction wear tests, and the friction wear types of the four samples were analyzed. A comparative analysis of experimental data led to the following conclusions: (1) Among the four samples, the Ni-based 30WC-coated sample exhibited the best self-lubricating properties. (2) The average wear area of H13 steel was 0.059 mm2, and the wear volume was 0.29 mm3; the average wear area of Co6-coated samples was 0.050 mm2, and the wear volume was 0.25 mm3; the average wear area of T400-coated samples was 0.002 mm2, and the wear volume was 0.01 mm3; and the average wear area of the Ni-based 30WC-coated sample was 0.035 mm2, and the wear volume was 0.17 mm3. In terms of wear resistance, the ranking from highest to lowest was: T400-coated sample > Ni-based 30WC-coated sample > Co6-coated sample > H13 steel. (3) Based on the classification of friction wear types, H13 steel primarily exhibited adhesive wear and oxidized wear; the Co6- and T400-coated samples primarily showed adhesive wear, abrasive wear and oxidized wear; and the Ni-based 30WC-coated sample mainly exhibited abrasive wear and oxidized wear.