High-Power Impulse Magnetron Sputter-Deposited Chromium-Based Coatings for Corrosion Protection

The use of high-power impulse magnetron sputtering (HIPIMS) to deposit chromium-based thin films on brass substrates for the purpose of corrosion-protective coating was investigated. By varying the process parameters (pulse frequency, pulse width and N2 flow rate) and structure design, including single-layer and multilayer structures, the obtained results revealed that the Cr-N films deposited through the use of HIPIMS exhibited higher film density and corrosion resistance compared to traditional direct-current magnetron sputtering. Based on the results of a field test using copper-accelerated acetic acid solution, the Cr-N film with a multilayered structure can further extend the time to corrosion onset. This is because the bottom layer in the multilayer structure can block structural defects in the layer above it, effectively reducing the penetration of corrosive agents into the substrate. The high bias voltage, coupled with increased temperature during deposition, led to a dezincification effect, resulting in the reduced adhesion of the film to the substrate and decreased overall corrosion resistance.